Page 1
SELECTABLE FEATURES
Note :
The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be
certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Wire Loop Selectable Features :
Wire Color
Closed Loop
Cut Loop
Gray Loop
Custom Code Manual Override
Valet Switch Manual Override
Green Loop
Voltage Sense
Hardwire
Note :
When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order
to begin the passive arming sequence.
RF Programmable Features :
Feature Selection
1 Chirp
2 Chirps
Default
First
1 Second Door Locks
3.5 Second Door Locks
1 Second
Second
Auto Lock On
Auto Lock Off
Auto Lock Off
Third
Auto Unlock On
Auto Unlock Off
Auto Unlock Off
Fourth
No Function
No Function
—————————-
Fifth
Passive Door Locks
Active Door Locks
Passive Locks
Sixth
Passive Arming
Active Arming
Active Arming
To program these selectable features;
Action
System Response
Turn ignition on
No response
Flip valet switch on then off 3 times
1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off
Short chirp, then long chirp
First
Then On
1 chirp = 1 second door locks
Press transmitter button 1 to change
2 chirps = 3.5 second door locks
o r
Second
Flip valet switch on then off
2 chirps = auto locks off
Press tranmitter button 1 to change
1 chirp = auto locks on
o r
Third
Flip valet switch on then off
2 chirps = auto unlock off
Press transmitter button 1 to change
1 chirp = auto unlock on
o r
Fourth
Flip valet switch on then off
1 chirp = No Function
Press transmitter button 1 to change
2 chirps = No Function
o r
Fifth
Flip valet switch on then off
1 chirp = passive locks
Press transmitter button 1 to change
2 chirps = active locks
o r
Sixth
Flip valet switch on then off
1 chirp = passive arming
Press transmitter button 1 to change
2 chirps = active arming
o r
Flip valet switch on then off
Exit program mode
o r
Turn ignition key off
Exit program mode
Note :
Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
Model APS 400
Installation Manual
