C
ALL
H
ANDLER
6000 I
NSTALLATION
I
NSTRUCTIONS
1
1
Preparation
•
Make sure that all the phone lines to be connected to the Call
Handler are standard pots (plain old telephone) lines (NOT T1,
ISDN or DSL lines).
•
Determine location of phone lines and phone numbers to be
connected to the Call Handler.
•
Determine which line will be used for downloads (the least
used line) and connect it to the Call Handler.
•
Determine if phone system has a music-on-hold port, the
location and type of connection.
•
Determine if customer has Caller ID. If Caller ID is built into
the phone system, then the Caller ID will not work because it
is blocked by the Call Handler. If a separate Caller ID device(s)
are used, then the Caller ID connection(s) to the phone line(s)
must be made between the phone line demarcation block
(entrance) and the RJ31X block(s) (you may need to re-wire
the Caller ID wiring to keep it connected in front of the Call
Handler).
•
Determine access to 120VAC for Call Handler power (Make
sure that the power is not switched off after business hours).
•
Decide mounting location for the Call Handler. Typically, this
will be in the phone closet.
•
Decide where you will cut each phone line and where you will
insert the RJ31X block in series with that phone line (The
RJ31X should be located within 3 feet of the Call Handler due
to cable lengths provided with the Call Handler).
continued next page...
