Graphic Wrap
™
Installation
Congratulations on your purchase of a
Power-Pole
®
Graphic Wrap.
This package includes: (2) matching
Power-Pole Graphic Wrap decals.
There are two options for installation
Option 1:
Apply wraps without disassembly with
Power-Pole anchor mounted on boat.
Option 2:
Disassemble the Power-Pole, apply wraps,
and then reassemble using complete bolt and
bushing rebuilt kit. This option requires the
purchase of a complete bolt and bushing set
specific for your Power-Pole.
For Technical Support Call 813-689-9932 opt 2
Installation Instructions - Option 2 (con’t)
Step 4 Applying Your Graphics Wraps:
Note: The top portion of the Graphic Wrap decal has the Power Pole
logo and should be placed at the top of the u-channels. The graphic
Wraps are slightly longer and wider than the u-channel allowing them
to hang over all sides. The excess will be trimmed off later.
A. Starting at the top end your graphic wrap decal, carefully peel about 10
inches from the back center portion of the decal (labeled with 3M logo).
B. Be sure the decal is centered down the u-channel then stick the top end of
the decal on the top end of the u-channel. Be sure that you have an equal
amount of decal hanging over all sides.
C. Carefully pull the backing off under the decal while sticking it down from the
top to the bottom of the u-channel. Apply slowly to avoid as many wrinkles
and air bubbles as possible.
D. Once the center portion is on, be sure there is plenty of decal on both sides
and turn the u-channel over rubber side up.
E. Slowly remove the backing from the sides of the decal without letting them
stick to the U-channel. Then carefully roll the u-channel back and forth onto
the graphic wrap avoiding as many wrinkles and air bubbles as possible.
F. Press the decal down next to the rubber running down the length of the
u-channel.
G. Using a razor knife trim off the excess material along the rubber and on the
ends of the u-channel.
H. Remove any remaining air bubbles by using the point of a razor knife or a
pin to poke a tiny hole in the air bubble, and then press smooth using finger
or other soft pliable material.
I. Using a razor knife cut a small X in the very center of each bolt hole and tuck
up under any overhanging edges.
J. Repeat steps A through I to apply graphics wrap to the second u-channel
Step 5 Reassembling your Power-Pole:
Use the specific Power-Pole
complete bolt and bushing set that is specific to your Power-Pole model
and size. Follow the rebuild instructions contained in the bolt set.
Product Quality Assurance
JL Marine Systems, Inc. assures that this product is made with the
finest quality materials and is free from manufacturer defects.
Please inspect this product immediately prior to installation.
If defects are apparent, please contact JL Marine Systems, Inc.
Warranty Department at 813-689-9932 immediately.
Please read all instructions carefully for proper product
installation. JL Marine Systems, Inc. is not responsible for
improper installation of product.
9010 Palm River Road, Tampa, Florida 33619
phone 813.689.9932 • fax 813.689.8883 •
power-pole.com
