Features
• This device is designed for use on KNX TP
1
communication bus as a:
–
line coupler
–
backbone coupler
–
repeater
• It provides data transfer between two separate lines and also isolates
the bus lines from each other in order to enable the independent
local operation of a bus line and allow line extension.
Important Notes
System Software – This device is configured with the ETS PC software
System Commissioning – During system commissioning this device
must be assigned its own unique physical address. Failure to do this can
result in malfunctions of other devices during initial start-up.
Installation – This device must only be installed and configured by
qualified professionals. If programming is required contact your local
agent for details.
Mounting Location – Install in a dry, well-ventilated location indoor only.
KNX Data Cable – Use approved KNX TP
1
data cable, segregate from
mains cable as per KNX installation recommendations and local wiring
rules. Connect devices in a ‘daisy chain’. Do not cut or terminate live
cables.
Installation – Device must be installed by KNX certified personnel
and cabled in accordance to the standards detailed on the official KNX
Association website.
Electrical Diagram
WARNING
•
•
•
• Do not connect KNX TP
1
bus to mains wiring.
• KNX TP
1
bus is SELV (Safety Extra Low Voltage)
and it must be isolated and segregated from mains
and other wiring as per the local wiring rules and
KNX installation recommendations.
• Do not open the device.
• Do not expose this device to rain or moisture.
• Check all wiring termination prior to energizing the
device.
• Installation, programming and maintenance must be
carried out by qualified personnel only.
PLC-KNX
LightMaster Line Coupler
INSTALLATION MANUAL
ISOLATE FROM MAINS SUPPLY PRIOR
TO INSTALLATION OR SERVICING. NO USER
SERVICEABLE PARTS INSIDE. INSTALLATION
AND SERVICE BY QUALIFIED PERSONNEL
ONLY
