Philips Domestic Appliances and Personal Care
Published by Philips Domestic Appliances and Personal Care
Printed in the Netherlands
© Copyright reserved
Subject to modification
City
Line
New York
Vacuum
cleaner
HR 8378
PRODUCT INFORMATION
- Maximum air displacement
: 34 l/sec
- Maximum vacuum water column
: 280 cm
- Power consumptio (IEC) 225V
: 1400 W
- Dust storage capacity
: 2 litres
- Cord length (depends on version)
: 6 m
- Filter system
: 6 fi lters
- Dimensions cleaner
: 37 x 28 x 23 cm
- Weight accessoiries
: 4.3 kg
- Noise
: 80 dB
- Colour
: Lilac Silver
- Remote controled motor rpm
- Cordwinder build-in with fl at cord
- Dustbag-full indicator in dustcover
OPTIONAL
Exhaust air fi lter
HR 6932 (8836 932 01210)
Sydney cotton dustbag
HR 6997 (8836 997 01010)
Sydney 3M dustbag
HR 6999 (8836 999 90010)
Sydney paper dustbags
HR 6999 (8836 999 01010)
Turbo brush
con
.
HR 6988 (4822 479 20196)
Polishing nozzle
con
.
HR 8040 (4322 004 22330)
4322 277 00364
02/0
8
SERVICE INFORMATION
- The Infrared remote control can adjust the suction power with
5 speeds. When switched on, the appliance always starts with
the highest power, even without a connected hose.
Use LR03 batteries, Alkaline is advised.
- To open the appliance, fi rst remove the screws A,B,C,D.
- To reach the motor remove the screws E.
- To disassemble the cordwider use Torx screw driver no T10,
which is one of set consisting of T20, T15, T10, T9, T8, T7 and
T6 = 4822 395 50145.
- Give attention that the contact fi ngers (item 45) are placed on the
cord-winder shaft in such a way that the pressure point of the
cordwinder knob to the cord winderlever (item 40) is vertical.
- The spare parts have been standardized as much as possible.
- Component confi guration on exploded view may differ in case of
specifi c versions, however, the actual components are distinguished
by means of code numbers.
- Item 1 Cotton dustbag is used in those countries where paper
dustbags are not available
- Item 41 Cord-winder spring unit is provided with a long spring, both
long and short cords can be used in combination with this spring.
- Cordwinder spring has to be tensioned till maximum minus approx.
1,5 revolution.
- First remove the 2 screws
B
of (item 15) hinge turn. Remove
(item 10) window of the PCB-
holder by placing a small screw-
driver in the recesses on both
sides of the window and opening
the snap connection.
- Remove the PCB-holder of
(item 10) from the upper housing
by placing a fl at screwdriver
between the front of the PCB-
holder and the upper housing as
shown in the drawing. The PCB-
holder has snaps which fi t into the
upper housing.
This product meets the requirements regard-
ing interference suppression on radio and TV.
After the product has been repaired, it should
function properly and has to meet the safety
requirements as offi cially laid down at this
moment.
