INSTALLATION GUIDE V1.0
DOMINUS EXTREME KIT
GLACIER series
PH-ASDOMKT_01
PACKAGE CONTENTS
WARNING
-
This product is intended for advanced users. Improper installation may result in damage to your equipment. While all efforts have
been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s) occurring to your
components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below instructions, or due to failure or defect in
the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.
Turn off the power to your system and discharge your body’s static electric charge before proceeding with the installation procedure. If you do not feel comfortable
with performing the installation procedure, consult a qualified computer technician.
For latest version check www.Phanteks.com
Clean off the original thermal compound.
We recommend using isopropanol alcohol.
STEP 1. REMOVING STOCK VRM COOLER
GLACIER DOMEX
QTY: 1
GLACIER Socket 3647
QTY: 1
Thermal Pads
QTY: 4
M2.5x10 Screws
QTY: 3
M3x10 Screws
QTY: 3
Thermal Compound
PH-NDC-01
QTY: 1
CPU Block D-RGB Cable
QTY: 1
VRM Block D-RGB Cable
QTY: 1
Unscrew all highlighted screws to remove
the stock VRM cooler and backplate.
STEP 2. APPLYING THERMAL PADS
Remove the protective film and place the
thermal pads on correct position on the
PCB components.
Make sure to unplug the LED and Fan
cables when you remove the stock cooler.
Make sure to remove the protective film on
both sides of the thermal pads.
Take the EVA-Foam from the box to use
as a base for your installation process.
