background image

These instructions were tested and are Dade County certified for single laminated glass and 
ASTM (Hallmark) certified for laminated insulating glass.

Part Number: 80GZ0102

©2008 Pella Corporation 

INSTALLATION INSTRUCTIONS - INSTRUCCIONES DE INSTALACION
ADVANCED PERFORMANCE AND HURRICANESHIELD® IMPACT RESISTANT 
CLAD FRAME AND CIRCLE HEAD WINDOWS IN WOOD FRAME CONSTRUCTION

Important Safety Information:

Pella

®

 HurricaneShield

®

 products have been tested in accordance with the large missile impact 

testing requirements of ASTM E 1886 and ASTM E 1996. Pella HurricaneShield products are 
neither hurricane proof nor are they shatter proof. Severe wind and rain may produce temporary 
conditions which exceed product performance standards. When these units are subjected to 
intense storms or extreme conditions, which exceed the intended design pressures, air, water and 
flying debris infiltration may occur. The performance of any building is dependent upon the 
design, installation, and workmanship of the entire building system. Pella Corporation strongly 
recommends consulting an experienced architect, contractor, or structural engineer prior to 
installation of Pella products. 

The individual (building owner, architect, contractor, installer and/or consumer) responsible 
for the project must take into account local conditions, building codes, inherent component 
limitations, the effects of aging and weathering on building components, and other design issues 
relevant to each project. The determination of the suitability of all building components for each 
project, as well as the design and installation of flashing and sealing systems, are the responsibility 
of the building owner, architect, contractor, installer and/or consumer.

/BJMJOH'JO

'JO$PSOFS

8BUFS3FTJTUJWF#BSSJFS

4IFBUIJOH

'SBNJOH

5PQ
'MBTIJOH
5BQF

0VUFS$PSOFS
'MBTIJOH5BQF

0VUFS
7FSUJDBM
'MBTIJOH
5BQF

4JEF
'MBTIJOH
5BQF

4JEF
'MBTIJOH
5BQF

4JMM'MBTIJOH5BQF

4JMM'MBTIJOH5BQF

0VUFS
7FSUJDBM
'MBTIJOH
5BQF

Always read the Pella

®

 Limited Warranty before purchasing or installing Pella products. By installing 

this product, you are acknowledging that this Limited Warranty is part of the terms of the sale. Failure 
to comply with Pella installation and maintenance instructions may void your Pella product warranty. 
See Limited Warranty for complete details at 

http://warranty.pella.com.

Summary of Contents for 80GZ0102










Reviews: