background image

INSTALLATION GUIDE

Diaz LED Illuminated Mirror 

500.40.70-75

Please read these instructions carefully before installation.

Installation should be carried out by a qualified electrician.

IEE Bathroom Zones

IMPORTANT

 

.

 

 

 

GENERAL

     

HANDLE WITH CARE!

 

 

COMPLIANCE

This product complies with the following safety standards: 

BS EN 60598-1: 2008+A11: 2009,  EN60598-2-1: 1989

WIRING

 

COLOUR CODING

LIVE 

Brown

NEUTRAL  Blue

 EARTH  Green & Yellow

zone

2

radius

zone

2

zone

2

225cm

zone

1

60CM

60CM

60CM

MIN

150mm

When unpacking never stand the unit on a hard 

surface. Always lay flat on a soft surface.

To avoid the risk of electrocution, please turn 

off the electricity mains supply before 

commencing installation.

Please do not hang or drape clothing or material 

over the mirror. LEDs can get very hot and this 

may cause a fire risk.

Please do not place objects too close to the LEDs 

as this will cause the object to burn or melt.

• THIS PRODUCT CONFORMS TO UK SAFETY STANDARDS AND MUST BE 

INSTALLED IN ACCORDANCE WITH CURRENT IEE WIRING REGULATIONS 

AND BUILDING REGULATIONS (PART P).

• THIS PRODUCT MUST BE EARTHED, AND SHOULD NOT BE CONNECTED 

TO AN UNEARTHED CIRCUIT. 

• ENSURE THAT CONNECTIONS ARE TURNED OFF AT THE CONSUMER 

UNIT OR FUSE BOARD BEFORE INSTALLING OR CARRYING OUT ANY 

MAINTENANCE.

• THIS PRODUCT IS FOR INDOOR USE ONLY.
• THIS PRODUCT IS IP44 RATED AND CAN BE INSTALLED IN BATHROOM 

ZONE 2 (AS DEFINED BY THE IEE WIRING REGULATIONS) AND BEYOND. 

SEE BATHROOM DIAGRAM.

• THE PRODUCT IS SUITABLE FOR INSTALLATION IN ZONE 2 OR HIGHER.
• IF THIS PRODUCT FEATURES REPLACEABLE BULBS THEN REPLACE FAILED 

BULBS IMMEDIATELY. ALLOW THE GLASS, LAMP AND FITTING TO COOL 

BEFORE REPLACING.

To ensure correct function of the sensor this 

product must be installed with a minimum distance 

of 150mm between the infrared sensor and any 

adjacent worktop, surface, obstruction or tile trim.

• 

When working at heights, please use a suitable platform to 

work from.

• 

Please note: For new installations, check for any electrical 

cables or pipe work (gas/water) in the vicinity of the intended 

mounting point before proceeding with the installation.

• 

Ensure that the fixing location is able to take the weight of the 

complete fitting.

• 

Wear suitable eye protection when drilling. Be careful when 

using power tools near water.

Do NOT strike mirror glass with hard or pointed items. It is 

recommended that the product is cleaned with a soft, dry, non 

abrasive cloth. Do NOT use cleaning agents or abrasive materials 

on any type of finished surface. Do NOT allow moisture to come 

into contact with the electrical components. Keep your bathroom 

well ventilated where possible.

This product is designed and manufactured in the Class 1 category, 

meaning a ground wire is required.

Diaz 500.40.70 

Diaz 500.40.71

Diaz 500.40.72

Diaz 500.40.73

Diaz 500.40.74

Diaz 500.40.75

Reviews: