Bidet Chair Manual
Designed for use with the
Mesh:
The Bidet Chair comes with a spare mesh seat
which is easily interchangeable and washable. To
remove the mesh slide out the metal rod; this allows
one side of the mesh to be removed, repeat the
process for the opposite side. Once removed, the
mesh can be washed (see washing instructions on the
mesh label). Before washing please remove all plastic
tubing from the mesh loops. Apply the tubing to the spare mesh seat. When fitting
the mesh ensure the washing label is towards the back of the seat (see image
above) and facing downwards.
Holding the mesh in place feed the metal rod through the 1st mesh loop (with the
tube inside) and through the first eyelet on the chair. Push the rod through the
section of mesh loops and through the next eyelet. Continue pushing the metal rod
through the third section of mesh loops, the last eyelet and the final section of
mesh loop until it can be pushed no further. Then use the Velcro at the end of the
metal rod to secure the rod in place.
For further information please contact PDS Hygiene on:
www.pdshygiene.com
Email: [email protected]
Tel: 01603 426 700
Fax: 08000 148 670
PDS Hygiene (part of Precision Design Services Limited)
Greyfriars, Greyfriars Close, Old Catton, Norwich, NR6 7DX
Tel: 01603 426700 Fax: 0800 014 8670
www.pdshygiene.com
