ZKTeco SpeedFace Reader - & SF1005-V+
Overview
Setting up Temp only mode
3rd Party
The SpeedFace reader can be used with Net2 to permit or
deny access based on the user’s temperature. When a tem-
perature is detected outside of the set threshold the reader
will notify the user that there is an abnormal temperature
and deny access.
This application note will run through the following modes
of operation:
•
Temp only
•
Token (MIFARE® only) + Temp
•
Face + Temp
Out of the box, the SpeedFace reader will detect a face, determine the temperature and providing it is
below the set threshold, permit access by firing the relay on the reader.
Using this method, the SpeedFace reader relay can be wired in line with a Paxton reader on the Yellow
data port. This will prevent the Paxton reader from functioning until the user has passed the tempera-
ture check.
NO
NC
COM
The default door lock delay on the SpeedFace reader is 5 seconds. To allow sufficient time for the user to
present their token to the Paxton reader, you may wish to increase this via the menu on the SpeedFace
reader.
*Allow unregistered access must be enabled in the SpeedFace reader for temperature only to work
properly.
1