PA28998A01_00
Page: 1 of 2
11-2017
PES400
PA28998A01
Rev. 00 11-2017
PANDUIT EMBOSSING SYSTEM
QUICK START GUIDE
© Panduit Corp. 2017
WARNING
TO REDUCE THE RISK OF INJURY, USER MUST READ
INSTRUCTION MANUAL
*The Operation Manual, PA28981A01, is located in the “Documentation“ folder on the
USB drive provided in the accessory bag. Page and figure numbers below reference
the Operation Manual.
*Easy-Mark Plus™ version 1.2 or higher, also located on the provided USB Drive, is
required to operate the PES400 Embossing System.
Quick Start Guide Checklist for Changing Plate Sizes and Embossing
□
Unlock cover with cover key and open machine cover.
□
Remove the top clamp by loosening both thumbscrews. see [Figure 1] on [Page 18].
□
Remove the top weight(s) [Figure 1].
(For 1.72 wide plates, complete Step 4.2.4 on
[Page
18]
first.)
□
Remove any remaining plates.
(For 1.72 wide plates, complete Step 4.2.4 on
[Page 18]
first.)
□
Loosen the right-hand side knob and slide the right-hand side wall to open the loader.
[Figure 1and Figure 5]
□
Change the Plate Support Block if needed, Step 4.2.5 on [Page 19] to determine correct
plate support block.
□
Put correct top clamp on and tighten.
□
Adjust the Gate Height [Page 23].
□
Remove top clamp.
□
Position Guide Rails [Page 26].
□
Load the plates [Page 28] with Easy Feed Humps up.
□
Put the top weight on [Figure 20].
□
Put the top clamp back on and tighten.
□
Align the
back edge
of Side Eject Guide Plate [Page 28].
□
Close machine cover.
□
Adjust the insert of the external hopper to corresponding slot or use corresponding insert
[Figure 24] on [Page 30].
□
Turn on PES400 [Page 31].
□
Run Easy-Mark Plus [Page 31].
***Version 1.2 or higher required***
□
Emboss one plate [Page 34] to review if embossing force adjustment [Page 34] is needed.
□
If any error happens, check the Error Codes on [Page 38] to debug the issue.
