For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2011
FS024
Opticom Fiber Optic Rack Mount Enclosure
Part Number: FRME1
Contents:
(1) FRME Enclosure
(1) Port I.D. Label
(2) EIA Enclosure Brackets
(1) FRME Kit
FRME Kit Contents:
(1) Grounding Lug
(2) Cable Ties
(1) #10-32 x 3/8" Screw
(1) #10-32 x 1/4" Screw
(4) #12-24 x 1/2" Screws
(4) M6 x 1.0 x 15MM Screws
(1) Fiber Caution Label
(1) Fiber Laser Warning Label
(2) Grommets
(2) #10-32 Hex Nuts
(1) Strain Relief Clip
Fiber Caution
Label
Fiber Laser
Warning Label
Grommet
GROMMET CUTTING DIAGRAM
Cut the small
circle for 1"
diameter
innerduct
Cut the large
circle for 1-1/2"
diameter
innerduct
Cut the straight
lines when not
using any
innerduct
Assembly Instructions
Determine the cable entry location on the enclosure.
Remove the knockout by inserting a screwdriver into the slot
located in the center of the knockout and apply a twisting
downward motion then lift out. Insert grommet following proper
cutting diagram. Grounding Lug attaches to a stud at the rear,
inside the enclosure on the top or bottom with a #10-32 nut.
Apply Laser Warning Label and Caution Label in a clearly visible
location. Apply Port I.D. Label(s) on the inside of the tray.
Port I.D. Label
Spool
Grounding Lug
Bracket
FRME1
