ACE02 Electronic Swinghandle with PROX Card
Reader Operating Instructions
visit
www.panduit.com
for latest version of this document
Page 1 of 4
Package Contents
•
ACE02 Electronic Swinghandle
with Proximity Reader (qty1)
•
M3x25 POZIDRIV
®
Mounting Screws (qty 4)
•
M3x14 POZIDRIV
®
Mounting Screw (qty 1)
•
Rotation Limiter (qty 1)
•
Rotation Limiter (qty1)
•
Pawl Screw (qty 1)
•
Lock Plug Screw (qty 1) (optional)
•
Top Mounting Bracket (qty 1)
•
Bottom Mounting Bracket (qty 1)
•
Operating Instructions (qty 1)
ACE02 Electronic Swinghandle with Proximity Reader
1.
Handle
2.
Prox Reader
3.
Tri-Color Status LED
4.
Lock Plug (optional)
Features
•
Installed 125kHz proximity reader module with Wiegand data
output
•
Remote lock and unlock capability
•
Single or multi-point lock actuation
•
Momentary or continuous lock actuation
•
Tri-color LED (blue/magenta/red) to indicate lock and handle
status
•
DIN lock manual override
•
Accommodates both left and right doors
•
For indoor use only
WARNING:
The ACE02 is shipped without a lockplug. This product
must be paired with an approved lock to function properly.
Use with an
unapproved lockplug voids the product warranty.
Specifications
Actuator Module
Supply Voltage (V
SUPPLY
): 12VDC to 24VDC (
NOTE
: Status LED will blink
red if the supply voltage is out of range.)
Standby Current:
50mA maximum at 12VDC
Operating Current:
200mA maximum at 12VDC (with no external
mechanical load applied to handle
Stall Current:
1A maximum (at 12VDC, limited to 2 seconds)
Operating Transit Time: 1 second maximum (
NOTE
: Power must be
present during transit times. If power is
removed while the lock slide is in transit, it will
complete its cycle when power is
restored.)
Electronic Unlock Time: 3 seconds minimum
Open Collector Outputs: Rated for V
SUPPLY
, maximum load
Proximity Reader Module
Supply Voltage (V
CC
):
12VDC to 24VDC
Operating Current:
20mA maximum (no external devices
attached)
Transmit Frequency:
125kHz FSK
DATA Signal Voltage:
5VDC
DATA Pulse Interval Time: 40µs
DATA Signal Delay:
2ms
Mounting and Installation
Please refer to product drawing for mounting and installation details.
NOTE:
Use a #1 POZIDRIV
®
driver when installing the mounting
screws. See product drawing for additional details.
Wiring Diagrams
The ACE02 contains two separate functional modules: the actuator
module and proximity reader module. The actuator module controls and
monitors the locking function of the swinghandle. The proximity module
reads the contents of a compatible proximity card and converts it to
Wiegand format.
These two modules operate independently of each other and require
connection to an access control unit (
not provided
), as illustrated below,
for the entire product to be fully functional.
