Page 1
Panasonic NS-700
Program an NT Type phone
Check that DHCP is On:
Power phone on
When you see SETUP in the LCD, Press the button below SETUP
Use the navigation disk and select Network
Press the button below ENTER
Look at the top of the LCD and be sure DHCP is Enable.
If it isn't, use the Navigation Disk to select Enable.
Press the button below EXIT
Press the button below EXIT
If you see "Data's changed!" STORE?
Select YES
------------------------------------------------------------------
Program the phone to reach the PBX
Power the phone down (by unplugging it from the wall, for 15 seconds.
Then, Power the phone back on
When you see SETUP in the LCD, press the button below SETUP
Use the Navigation Disk and select PBX
Press the button below ENTER
Select PBX IP Address
Press the button below ENTER
Select Primary PBX
Press the button below ENTER
Enter this IP Address 192.168.2.159
