![background image](http://html1.mh-extra.com/html/painless-performance-products/60103/60103_quick-start-manual_3259217001.webp)
2501 Ludelle Street
Fort Worth, Texas 76105
817-244-6212 Phone • 817-244-4024 Fax
888-350-6588 Sales • 800-423-9696 Tech
E-mail: [email protected]
Web: www.painlessperformance.com
ADD ON LATE T.P.I. EMISSIONS KIT
Part #60103, 60203, 60314 & 60315
THE EMISSIONS WIRES IN THIS KIT INCLUDE: THE WIRING FOR THE
CHARCOAL CANISTER, THE AIR PORT SOLENOID AND THE AIR PUMP
DIVERTER VALVE.
STEP 1 - INSTALLATION OF CONNECTORS IN THE ENGINE COMPARTMENT
INSTALL THE FOLLOWING CONNECTORS INTO THESE LOCATIONS:
THE RED CONNECTOR WITH THE DARK GREEN/YELLOW AND BLACK/PINK
WIRES PLUGS INTO THE CHARCOAL CANISTER MOUNTED IN THE ENGINE
COMPARTMENT.
THE BLACK CONNECTOR WITH THE BLACK/RED AND BLACK/PINK WIRES
PLUGS INTO THE AIR PORT SOLENOID LOCATED ON THE BACK OF THE
AIR
PUMP.
THE GRAY CONNECTOR WITH THE BROWN AND BLACK/PINK WIRES PLUGS
INTO THE AIR PUMP DIVERTER VALVE LOCATED BEHIND THE AIR PUMP.
STEP 2 - ROUTING THE WIRES
ROUTE ALL OF THE WIRES FROM THE FRONT THREE CONNECTORS UP TO
THE COOLANT TEMPERATURE SENDING UNIT LOCATED AT THE FRONT OF
THE ENGINE NEXT TO THE THERMOSTAT HOUSING. USING TIE WRAPS
SECURE THE WIRING TO THE COOLANT TEMP SENSOR (BLACK AND
YELLOW) WIRES ALL THE WAY BACK TO THE COMPUTER LOCATED INSIDE
THE VEHICLE. BE SURE TO LEAVE ENOUGH SLACK FOR ANY POSSIBLE
ENGINE MOVEMENT.
CAUTION: BE
CAREFUL ROUTING THE WIRES THROUGH THE FIREWALL TO
AVOID DAMAGING THE TERMINALS ON THE ENDS OF THE
WIRES.
STEP 3 - ATTACHING THE B+ POWER WIRES
YOU WILL FIND THAT THE THREE BLACK/PINK WIRES END NEAR THE
BACK OF THE ENGINE BLOCK. THESE WIRES SHOULD BE SPLICED INTO
THE PINK/BLACK WIRE COMING FROM THE EGR SOLENOID CONNECTOR.
THESE WIRES CAN ALSO BE EXTENDED AND CONNECTED TO A 12 VOLT
IGNITION ONLY (SWITCHED) POWER SOURCE IF YOU WISH TO DO SO.
STEP 4 - UNPLUGGING THE COMPUTER
CAUTION: REMOVING THE COMPUTER CONNECTORS FROM THE COMPUTER
WHILE THE IGNITION IS ON WILL DAMAGE THE COMPUTER!
60314-60315.doc
07/22/2004
1