INSTALLATION GUIDE
FHUS Series LED High Bay
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2020 PacLights All Rights Reserved
Page 1 of 3
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
02-00044-200818
FHUS HOOK MOUNT
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
•
Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FIG.1
FHUS 3/4” CONDUIT PENDANT MOUNT
FIG.3
FHUS 060/080/100/120/150 (Universal or 480v) FHUS 200/250 (Universal or 480v)
The Hook Mount can be used to hang the FHUS to a desired
height. Remove the Trunnion Mount by removing the Bracket
Screws. Loosen the Set Screw to install the Hook Mount. Screw
the Hook Mount into the top of the FHUS fi xture. Tighten the Set
Screw to hold the Hook Mount in place.
Connect the ACL and the ACN from the FHUS Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
FHUS DRIVER
GRA
Y (-)
PURPLE (+)
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
WIRING DIAGRAM
DIM
INPUT
FHUS HOOK MOUNT
SET
SCREW
The 3/4’ NPT Conduit Pendant Mount can be used to hang the
FHUS fi xture from a conduit. Install by screwing the Pendant
Mount into the top of the FHUS Fixture. Attach the Power and
Dim Cables to the appropriate entries of the Pendant Mount
Housing. Note: FHUS HV 200 & 250 have a specifi c Pendant
Mount Adapter. Refer to FIG 1. for Trunnion Mount Removal.
FHUS PENDANT
MOUNT
PENDANT MOUNT
ADAPTER (for HV Models)
FIG.4
CONDUIT
POWER
CABLE
DIM
CABLE
FHUS FIXTURE
FHUS TRUNNION
MOUNT
SCREWS
FIG.2
