10400452-001 05/2013
©2013 Overland Storage, Inc.
Page 1 of 4
*10400452-001*
SnapServer
™
NAS N2000
Spare Chassis Instructions
This document describes how to replace the chassis of a NAS
N2000 from Overland Storage.
WARNING:
To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
AVERTISSEMENT:
Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION:
While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
Prepare the Unit
Power Off and Disconnect
1.
Power off the unit by pressing the
Power button
on the
front of the server for
no more
than one second.
While there is no obvious change, the appliance starts its
shutdown process.
2.
When all the front LEDs are off, disconnect the
power
cords
.
3.
Disconnect all remaining
cables
from the unit.
Remove the Front Bezel
Remove the
bezel
by pressing the latch on the right side,
pulling the right side away from the unit, and pulling the bezel
off to the right.
Set the bezel aside.
Remove the Drives
IMPORTANT: Overland recommends that you remove the
drive assemblies to lessen the unit’s weight prior to removal.
NOTE: Do not remove the disk drives from their carriers. Doing so
voids the drive warranty.
1.
Press the release
button
on the right side of the carrier.
2.
Using the built-in
handle
, pull the drive carrier out.
3.
Number the drive
and set it on a secure surface.
4.
all
the remaining drive carriers.
Power
Power
LED
Press
Rack
Screw
