Office Pro UPS1000VA/1500VA Users Manual
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS –
This manual contains important instructions that should be followed during installation and maintenance of the UPS and batteries.
CAUTION-
- Intended for installation in a controlled environment.
- Maximum ambient temperature 95°F.
- Servicing of batteries should be performed or supervised by personnel knowledgeable of batteries and the required precautions. Keep unauthorized
personnel away from battery.
- To reduce the risk of fire, connect only to a circuit provided with 20 amperes maximum branch circuit overcurrent protection in accordance with the National
Electric Code, ANSI/NFPA.
SETUP
1
Inspection
Inspect the UPS upon receipt. Notify the carrier and
dealer if there is damage. The package is
recyclable; save it for reuse or dispose of it properly.
2 Placement
3
Check the Site Wiring
Fault Indicator
Caution:
If the site wiring fault indicator lights, get a
qualified electrician to correct the building wiring.
4
Connect the loads
First, connect the UPS to the AC input power
source. Next, plug your computer, monitor, or other
devices into the receptacles on the rear of the UPS.
To use the UPS as a master “On/Off” switch, make
sure that all of the connected
devices are switched
“On”.
Caution:
To prevent an overloading condition, do
not connect a laser printer to the backup outlets.
These UPS outlets provide battery power to the
connected equipment when utility voltage is outside
acceptable limits.
5
RJ11/RJ45 Connector
(Optional) Provide an RJ11/RJ45 connector to
extend the connection of telecommunication/network
cable.
6
Connect Computer
Interface Port
(Optional) Connect the optional interface cable to
the USB interface port on the back of the UPS.
Connect to the computer. See software
documentation for installation instruction.
7
Operation Test
1. Connect the UPS to the wall receptacle.
2. Press the Power button on the front panel, verify
that the Green Line (
) LED is on.
3.
Connect your computer equipment to the
receptacles on the back of the UPS. Unplug the
input power cable of the UPS from the wall
receptacle to check if the Line (
) and
Inverter(
) LED are flashing every 2 seconds.
Verify that the audible alarm is beeping.
4. The ups is now running on internal battery to
support the connected equipment.
5. Reconnect the ups to the wall receptacle to
complete the test. The audible alarm will silence
and the Green Line LED will be visible.
6. IMPORTANT: Plug the UPS into the wall outlet
to charge the internal battery for a minimum of 8
hours prior to using the UPS.
7. STORAGE:
Store at -15 to +30
°
C (+5 to +86
°
F), charge the
UPS battery every six months.
Store at +30 to +45
°
C (+86 to +113
°
F), charge
the UPS battery every three months.
IN
O UT
192321942005001
Orion Power Systems, Inc.
Toll-Free: 877-385-1654
8640 Philips Hwy
www.orionpowersystems.com
Jacksonville, FL 32256
