Bike pod
Model: AD202
The AD202 bike pod is equipped with the latest
2.4GHz ANT+ Sports System to achieve reliable
transmission linkage with other devices.
PACKAGE ITEMS
The package should include the following items:
•
1 x AD202 bike pod and cushion
•
1 x magnet (plastic base)
•
1 x magnet (with screw)
•
6 x nylon cable ties
•
1 x CR2032 3V lithium batteries (already
installed in bike pod)
SELECT MEASURMENT MODE
This bike pod measures speed and cadence. First
decide what you wish to measure as the
positioning of the bike pod depends on the chosen
measurement mode.
To select measurement mode (speed / cadence):
1. Use a coin to open the battery compartment lid
by turning it anticlockwise.
2. Remove
the
battery.
3. Slide switch to select SPEED or CADENCE
(refer to markings on the unit).
4. Put battery back into place.
5. Secure the lid by turning clockwise.
6. Insert sensor into the provided cushion to help
achieve a better grip on the bicycle.
INSTALLING THE BIKE POD
SPEED
1. Position sensor onto one side of the bicycle fork,
with logo visible.
2. Thread a nylon cable tie through each of the
holes on the sensor. Loop cable tie around the
bicycle fork, then thread the end through the
opening and past the ratchet. Pull to secure
into place.
TIP
Cut away unnecessary cable tie to avoid it
being caught in the wheel while in motion.
3. Unscrew magnet and press slot onto spoke,
with flat magnet surface facing sensor.
4. Using the alignment notch as a guide, position
magnet so that it will pass the sensor at the
correct position. Screw into place.
NOTE
Improper alignment may affects sensor’s
performance.
CADENCE
1. Choose the crank arm which is not on the same
side as the chain ring. Place magnet (with
plastic base) onto the crank arm of the pedal,
making sure the magnet faces the chain ring.
