![background image](http://html1.mh-extra.com/html/orangerx/r110x/r110x_user-manual_1646623001.webp)
O
RANGE
R110
X RECEIVER
U
SER
M
ANUAL
F
EATURES
:
• Compatible with DSM2/DSMX 1024/2048 aircraft radio and module systems
• 6-12 channel satellite output allowing for single line connection with compatible devices
• True diversity antennas
• Wide input voltage: 3.3V
• Size: 19x27x10mm
• Weight: 3g
Current consumption: 35mA
C
OMPATIBILITY
This satellite module has been tested and fully compatible with following equipment:
Receivers:
• Spektrum AR6210-x, AR8000-x, AR12120-x
• Orange 620x, 720x, 820x, 920x, 1020x, 1220x
• Spektrum and Orange telemetry modules
Flight Controllers
:
• Naze32
• CC3D
• KK2
• MultiWii
• APM(2.0 and up)
Flybarless Controllers:
• V-Bar (and compatible)
• iKON
Diversity controllers
• Orange 6 satellite diversity controller
S
ATELLITE
I
NSTALLATION
The
R110
X
incorporates diversity antennas, offering the security of dual path RF redundancy
By orienting these antennas in degree, each antenna is exposed to its own RF environment,
greatly improving path diversity (the ability for the receiver to see the signal in all conditions).
A
NTENNA
P
OLARIZATION
For optimum RF link performance it’s important that the antennas are in an orientation
that allows for the best possible signal reception when the aircraft is in all possible attitudes and
positions. This is known as antenna polarization. If you use several satellites in your system or a receiver and one or more
satellites make sure that the antennas are oriented perpendicular to each other; typically vertical and horizontal and at different angles.
B
INDING PROCEDURE
Currently not only receivers can initiate binding procedure for satellites. Flybarless(FBL) controllers and flight controls(FC) can also do it. If you
want to bind one or more satellites using FBL or FC please read manual on the FBL or FC you have.
Below is the binding procedure using satellite having satellite ports.
1.
Connect satellite to the receiver using 3 wire cable. For Nuvoton series receivers if you use only one satellite, plug it to the port 1
2.
Install a bind plug into BIND connector of your receiver.
3.
Apply power to the receiver.