Close supervision is necessary when any motorized screen
is used by or near children,do not leave motorized screen
unattended while in use.
Do not operate motorized screen with damaged cord or if the
motorized screen has been dropped or damaged,until it has
been examined by a qualified service technician.
Position the cord so that it will not be tripped over,pulled or in
contact with not surgaces.
Never yank cord to pull plug form outlet.aways grasp plug bu
head and pull to disconnect.
Let appliance cool completely before putting away.Loop cord
loosely around appliance when stoing.
To reduce the risk of electric shock,do not immerse this motor-
ized screen in water or other liquids.
To reduce the risk of electric shock,do not disassemble this
appliance,only a qualifid service technician may service or
repair motorized screen.Incorrect reassemble can cause
electric shock when the motorized screen is used.
Only use accessory attachment recommended by the
manufacturer.Use of non-manufacturer recommended
accessory attachments,may viod the screens warranty
and release Panoview of all liability.
Basic electrical safety precautions should always be
observed.
In the event,the above mentioned safety precautions are not
observed.The warranty may be viod and Panoview released
of all liability.
Basic safety precautions,including the following should
always be followed.
IMPORTANT SAFETY INSTRUCTIONS
Screen does not travel far enough into case:
Make sure middle fasten screw (F) loosened,then
loosen small left fasten screw (FL) .Turn left screw (LS)
counterclockwise to increase the amount of up travel.Run
the screen up to test the stop position.If more travel ie
desired,adjust the limit switch again.Repeat until the desired
position is set.When complete fasten middle fasten screw
(F) and small left fasten screw (FR).
