ELECTRICAL CONNECTION
Manufacturer:
Terazidere Mah.60.Yil Cad.No:5/3
34035 Bayrampasa/ISTANBUL/TURKEY
TEL: 0 212 501 48 63
FAX: 0 212 501 48 83
Email:
MODEL OP-CN4
UNIVERSAL
INCREMENTAL
COUNTER
Ver 2.0E
USER GUIDE
WARNING!
READ CAREFULLY BEFORE POWER ON
1.
Complete electrical connections according to the
schematic at the last page.
2.
Check Supply Voltage 220V (or 24V optional) AC, or DC, due to
Specifications on the equipment.
3.
Use only shielded cable for sensors.
4.
Keep away the equipment from direct heat source.
5.
MODEL OP-CN4 is not suitable for outdoor use.
6.
Keep away the equipment from water or other liquid
drains.
7.
Do not open, modify or replace any component in the
equipment, If any problem occurs please contact an authorised
OPKON technical service or OPKON directly.
ELECTRICAL SPECIFICATIONS:
Microcontroller based
A /B /Z(Reset)-4 X Counter mode
200 kHz Max. counting frequency
2 X Relays output
1 X SSR output
Incremental or absolute positioning mode
Holding on the last value in memory
10 X Output modes
Offset calibration
Password to protect menus
Power Supply
:220V ± % 20 (or 24V optional)
,50 Hz
Power Consumption
:<4 VA (protected by fuse 50mA)
Sensor supply voltage
:+5V or +12VDC (selectable by jumper)
Sensor supply current
:Max.100mA(no fuse)
Relays max. ratings
:Relay1
1xNO+NC 8A,230V AC
Relay2
1xNO+NC 8A,230V AC
SSR output
:5V DC (non-isolated)
MECHANICAL SPECIFICATIONS:
Dimensions
:72x72x90 mm
Panel cut dimensions :67x67mm
Body
:ABS plastic
Working temperature :0-60 ºC
Storage temperature :-10ºC …+80ºC
Humidity :
<%90 RH
