301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 9
INSTRUCTION/INSTALLATION SHEET
lyriQ™ High Performance Keypad
IS-0369 REV. D
©Copyright 2009 by On-Q/Legrand All Rights Reserved.
1. Introduction
The lyriQ™ High Performance Keypad, P/N AU1000-xx
(see
Figure 1
),
is an
integral part of the lyriQ™ Multi-Room Audio System. It is a component which,
when combined with other essential components ( a Source Input Unit,
Distribution Module and Speakers) and your source equipment (receiver, CD
player, etc.), creates a versatile whole-house audio system that will fill your
rooms with high-quality sound for years to come. It uses Category 5 wiring to
distribute audio signals, control information and IR for remote control. The High
Performance Keypad has on-board 20 Watt per channel class D amplifiers to
provide a rich level of clean sound even in outdoor or large room applications.
It also contains a full set of features, including the ability to control all other
keypad volume controls in the house. Build a system that accommodates the
needs of any space by combining the lyriQ™ High Performance Keypad with
the lyriQ™ Standard Keypad (P/N AU7394-xx) in the same system. The
AU1000-xx is available in white (-WH), light almond (-LA), ivory (-IV), or black
(-BK).
2. Description
The front panel of the lyriQ™ High Performance Keypad, PN AU1000-xx
(see
Figure 1
),
looks almost identical to the lyriQ™ Standard Keypad (AU7394-xx). It
also has push buttons for VOLUME UP/DOWN (with five associated green
Volume Bar Graph LEDs), SOURCE (with four green Source Selection LEDs)
and MUTE (with one red status LED). There is also an IR target window and tri-
colored status LED. The visual cue from the front panel that this is a High
Performance Volume Control are the parenthesis surrounding the music note in
the lower right hand corner.
NOTE: lyriQ™ Keypads are recommended for indoor use only.
On the rear of the lyriQ™ High Performance Keypad (see
Figure 2
) the Category
5 connection is an RJ45 jack (J1). The TB2 speaker output connections (left and
right, plus and minus) are spring loaded and designed to support up to 14 gauge
wire. The TB3 Line Out connections (plus and minus) are also spring loaded and
designed to support up to 14 gauge wire. This mono-summed output is designed
for powered sub-woofers and as such is filtered through an 80Hz low pass filter.
The other terminal block on the rear (TB1) is used for powering the keypad. Up to
14 gauge speaker wire may be used for this purpose, and this speaker wire (two
conductor or four conductor) is run from a power distribution module (P/N
AU1001) in the enclosure to the ketpad. We recommend 16/4 speaker wire,
since it is available paired with Category 5 from a variety of sources. Again, the
TB1 connections are spring loaded (plus and minus) with the two plus
connections on the red portion of TB1 and the two minus connections on the
black portion of TB1. For ease of installation, connect the red wire and white wire
to the red (plus) portion of TB1 and the black and green wire to the black (minus)
portion of TB1.
Figure 1
Figure 2
