ATTENTION!!!
ZLD-XX/EM/ADR
ADDRESSABLE
SELF TESTING MAINTAINED
EMERGENCY ILLUMINATION SIGNS
IP40
922502862_09_009
922502862_09_009
4
5
C:
Including inhibiting mode
LABELING EXPLANATION:
B:
Including remote test mode
NOTE:
LED= Light Emitting Diode
X:
Self contained
1:
Maintained operation
(*)
A:
Including test device
G:
Internally illuminated safety sign
(*)
Maintained operation: The luminaire lights its illumination source, when it is powered
by the mains power supply or not
.
Non Maintained operation: The luminaire lights its illumination source,
only in mains
power supply’s failure.
180:
3 hours duration
Warranty
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of warranty is
specified in the official catalogue of Olympia Electronics and also in the technical leaflet, which accompanies
each product. This warranty ceases to exist if the buyer does not follow the technical instructions included in
official documents given by Olympia Electronics or if the buyer modifies the goods provided or has any
repairs or re-setting done by a third party, unless Olympia Electronics has fully agreed to them in writing.
Products that have been damaged can be returned to the premises of our company for repair or
replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not
charge the
buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or not the
buyer the transportation cost.
European
manufacturers
72
nd
km
.
O
.
N
.
R
.
Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.com
Non
maintained
NM
Thank you for your trust in our products
Olympia Electronics - European manufacturer
16m
30m
38m
Maintained
Μ
Warranty
The light source of this luminaire is not replaceable when the light source reaches
its end of life the whole luminaire shall be replaced.
Battery Replacement
Dimensional Drawings (mm)
Olympia Electronics S.A
.
8.5- 10.5V DC
1200mW
1400mW
1600mW
1111153
1211153
1311153
45 °C max. across the board
Non reversible connection between main pcb and led module
LED Characteristics
MANUFACTURER
MODEL NUMBER
VOLTAGE RANGE
CONNECTIONS
NOMINAL POWER
TEMPERATURE (tc)
220-240V AC
/ 50-60Hz
3.8W / 6.5VA
28mA
1.3
0.60
0.62
4W / 6.7VA
29mA
19V
4.3W / 6.9VA
30mA
Technical Characteristics
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
SUPPLY CURRENT
3.6V / 1.5
Ah
BATTERY (Ni-MH)
INSULATION BETWEEN SUPPLY & BATTERY CIRCUIT
WIRE CROSS SECTION
U-OUT
EOFi
Basic insulation
2
2
0.3mm - 3.3mm (22-12AWG)
BATTERY PROTECTION
18
white
LEDs
21
white
LEDs
24
white
LEDs
3h
CHARGE TIME
MINIMUM DURATION
LIGHT SOURCE
24 hours
LED Charge, Lamp Fault LED, Battery Fault LED
EN 60598-1, EN 60598-2-22, ΕΝ 55015,
ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
IP40
16m
30m
38m
VIEWING DISTANCE
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
o
5
to 40 C
Aluminum, Acrylic Plate, ABS/PC
1145gr.
1585gr.
780gr.
290 x 38 x 172 mm
350 x 38 x 242 mm
450 x 38 x 295 mm
RELATIVE HUMIDITY
CONSTRUCTION MATERIAL
EXTERNAL DIMENSION (L x W x H)
WEIGHT
GUARANTEE
Up to 95%
3 years (1 year for the battery)
INDICATIONS
Deep discharge and overcharge protection / the control gear will recharge the battery normally after the test of 22.3
270 - 360mA
310mA
270 - 370mA
315mA
255 - 360mA
290mA
140 - 165mA
MIN MAX. DISCHARGE VOLTAGE
MIN MAX. DISCHARGE CURRENT
Rated CURRENT @3.6V
MIN MAX. CHARGE CURRENT
MAX CHARGE VOLTAGE
3 - 4.2V
5V
LIGHT SOURCE LUMINOUS FLUX (MAINS / EMERGENCY)
125lm/125lm
145lm/125lm
170lm/125lm
CONTROL GEAR WITH AUTOMATIC
TEST FUNCTION
125/145/170lm
Light output
Ni-MH
Battery
2
2
1
1
It can be done only by a competent person and after the mains interruption
.
Remove the old battery and place a new one of the same type and characteristics and
assembly the luminaire.
WARNING
!!
Use a maximum torque of
0,25Ν
m
to tighten the screws
.
A B C G
1
X
1 8 0
ZLD-28/EM/ADR
ZLD-28/EM/ADR: 290 x 38 x 172mm
ZLD-34/EM/ADR
ZLD-34/EM/ADR: 350 x 38 x 242mm
ZLD-28/EM/ADR
ZLD-34/EM/ADR
ZLD-44/EM/ADR
ZLD-44/EM/ADR
ZLD-44/EM/ADR: 450 x 38 x 295mm
172
290
350
450
242 295
38
36
50
182
100
46
44
70
Controlgear classification in accordance with IEC 62034: with automatic test function
The controlgear has mains-connected windings of transformer
The controlgear
is suitable for LED modules only
The controlgear is proof against supply voltage polarity reversal
The lamp controlgear relies upon the luminaire enclosure for protection against accidental contact with live part (7.2 BS EN 61347-2-7)
Integrated SPD
3h
Duration
ADR
