MicroWalsh Sat Omni
Dimensions
`
6 x 6 x 27 in
Recommended Amplifier
35-125 watts
Impedance (typical)
4 Ω
Frequency Response
80 - 20,000 Hz
Sensitivity @2.8 Volts
85 dB
Recommended Distance
up to 10 ft.
Congratulations! You are now the proud new owner of a pair of Ohm MicroWalsh Omnidirectional Satellites! This
speaker is specially designed to give you a spacious, enveloping feeling for surround effects in movies. Given the correct
placement, our design will make you feel like you’re right there, inside the film – more so than any other speaker on the
market.
Following are the simple instructions for installation. It will take some experimenting with room placement to optimize
the performance in your home. Do this at your leisure with a variety of music. No one set-up is best for all rooms and
music.
Connecting the loudspeakers:
The Ohm MicroWalsh Sat Omni is wall hanging loudspeaker equipped with gold plated binding posts on the back of
the cabinet. These terminals will accept any standard type of wire connector, including bare wire. Note the groove
routed in the top and bottom of the back of the cabinet (illustrated below). This is to allow you to run the wire to the
speaker either from above or below the speaker as it hangs flush to the wall, without crimping your wire.
Before connecting your loudspeakers, unplug your receiver/amplifier and make sure you have the right kind of wire.
We strongly recommend 12 AWG speaker wire.
Strip no more than ½” of insulation off both ends of the speaker wire with wire strippers, scissors, or a sharp knife .
By twirling the exposed ends between your thumb and forefinger, you can prevent stray strands of wire from shorting
out the terminals.
Leave lots of slack in the speaker wire until after you decide where the loudspeakers should be placed, so the
components can be moved around without straining the connections.
Note that one side of the speaker wire has a ridge or a printed stripe running its entire length, while the other side is
left unmarked. To assure in-phase operation, make sure to connect the marked side of the speaker wire with the red
(positive) terminal on the receiver on one end and the red binding post on the back of your MicroWalsh on the other
end. Then connect the unmarked side of the speaker wire to the negative (ground) terminal on your amplifier on one
Ohm Acoustics Corp.
76 Degraw Street
Brooklyn, NY 11231
ohmspeaker.com
