Ascending
Descending
Push up the throttle stick, and the spinning
speed of the main blades will increase.
the aerocraft begins to ascend.
Pull down the throttle stick, and the spinning
speed of the main blades will decrease.
the aerocraft begins to descend.
2
3
4
1. The remote controlled distance will be shorten when the power (aerocraft or transmitter) is insufficient.
2. It is difficult to take off or fly not high when aerocraft’ s power is insufficient.
3. When the aerocraft is damaged, please repair it in time and stop operating, or it may lead to injury.
4. If you do not use the transmitter for a long time, please remove the batteries to avoid the batteries’ leakage.
5. Do not drop the transmitter from the high altitude or crash it badly, otherwise, it will shorten the transmitter’s using life.
PRECAUTIONS:
NOTICE:
If the drone is rotating in the air uncontrollably, adjust the ruddertrimming buttons until the drone is stable.
PREPATATION FOR FLIGHT:
1. please operate in spacious indoor or outdoor without rain or snow,and wind power should be below 4 grade,be away
from people,animals and obstacle.
2. Make sure the battery of the quadcopter is well installed and connected.Turn on the switch of the quadcopter,the
indication light of the quadcopter is flashing,then put it on the flat place and wait for the frequency adjustment.
3. Turn on the switch of the transmitter,pull the throttle stick to the highest position,and then pull the throttle stick down
to the lowest position.There indication light of the quadcopter is on,that means the frequency adjustment is connected
completly and it is ready for flight.
THE INSTRUCTION OF LITHIUM BATTERT CHARGING
REMOTE CONTROL BATTERY INSTALLATION
Fig.1
Fig.2
Fig.3
1.Make sure the voltage of the USB charger fits the local electricity supply.
2.The Charging plug will overheat if overcharged. Please stop charging immediately as it may cause damage to the
battery.
3.Do not leave the battery aside when charging.
4.Do not use other chargers other than the one supplied in consideration of safety.
5.Recharge the battery 30 minutes later after flying, because the battery temperature could be too high when flying and
charging immediately could damage the battery.
6.Do not leave the battery in the fire in consideration of safety.
7.Do not short circuit the battery. Do not leave the battery together with tiny medal parts in consideration of safety.
Open the aircraft battery cover and connect the plug on the lithium battery wire end to the wire outlet in the aircraft
battery bay.(Fig.1)
Install the lithium battery into the battery compartment and cover the aircraft battery cover.(Fig.2)
Insert the USB charging cable plug into the USB power socket, and then connect the other end to the charging socket
of the aircraft. When charging, the LED lights on. When the charging is completed, the LED lights off. The charging
time is about 60 minutes.(Fig.3)
After the charging is completed, the aircraft's power switch is turned on, and the light of the aircraft body is slowly
flashing. At this time, the aircraft is looking for a frequency indication.
Attention:
1.Remove the battery cover from the back of controller (Fig. A)
2.Install 3 “AA” batteries into the controller, make sure to
install batteries to their correct polarity. (Fig. B)
Do not mix old and new batteries or battery types.
3.Replace the battery cover
Fig.A
Fig.B
3“AA”Batteries
(Not Included)
Turn right
Push the rudder stick to the left, and the
aerocraft will turn to left.
Push the rudder stick to the right, and the
aerocraft will turn to right.
Turn left
AGE: 14+
1
If the aircraft can not be vertical rise up , need to re-set it , press the throttle
lever and direction of operation joystick to the bottom right corner of the controller
for 3 seconds , indicator will flashes quickly , after it stop flashing ,then loosen all
the remote control button , the calibration is completely.
Forward
Backward
When push the right lever (steering rudder) to
the right, the aerocraft will fly to the right.
When push the right lever (steering rudder) to
the left, the aerocraft will fly to the left.
When the rudder stick is pushed upward,
the aerocraft swashplate will downtilt and it
advances.
When the rudder stick is pushed downward,
the aerocraft will uptilt and it recedes.
Left
sideward
fly
Left
sideward
fly
Right
sideward
fly
Right
sideward
fly
THE PROBLEM REASON COUNTERMEASURES
The indication light of the quadcopter
is flashing and without reaction when
operated.
The quadcopter blades turn around
but the quadcopter canot take off.
1.Frequency modulation between the
quadcopter and remote control is not
operated correctly.
2.Insufficient battery power.
1.Insufficient battery power.
2.The blades distorted.
1.Refer to the Preparation for taking off, and
re-modulate the frequency.
2.Recharge the battery.
1.Recharge the battery.
2.Replace the blades.
The fine tuning button are all on but
the quadcopter still couldn’t keep
balance.
1.The blades distorted.
2.The motor doesn’t work properly.
1.Replace the blades.
2.Replace the motor.
The quadcopter shakes hardly.
The blades distorted.
Replace the blades
The quadcopter loss of control
after crashing.
Three-axis acceleration sensor lose it’s
balance after crashing.
Put the quadcopter on the ground for 5-10
seconds.
COMMON PROBLEM AND SOLUTION INSTRUCTION:
MANIPULATION METHOD
FIXED VERSION FUNCTION KEYS & NAME DESCRIPTION
14.Gyroscope correction
10.Turn right trim
11.Turn left trim
1.Speed setting
12.Power on/off
2.360° flip
5.Left stick
(ascend/descend/
turn left/turn right)
6.Right stick
(forward/backward/
left and right side flying)
3.Forward trim
4.Backward trim
8.Left fly trim
9.Right fly trim
15.Reset
13.Indicator
After the frequency, the throttle
to push to unlock
Low/medium/hight speed setting adjust the aircraft left / right / forward / backward / left / right side
fly speed.
Speed setting
Serial
Number
Function keys /
Names
Function / Effect
1
2
360° Flip
This button is for 360 degree flip function , control the aircraft achieve the 3D flip function.
Power ON/OFF
Left stick
Right stick
Remote controls power switch,short open the power,and then long press 3 seconds cut off power supply.
Up/down, left/right turn 360° rotation.
Forward/backward, left/right.
Headless mode
To activate Headless Mode,press the Headless button
Turn right/left trim
Forward/backward
trim
Left/ right fly trim
If the vehicle move left (right) without operation,press right (left) trim button correspondingly.
If the vehicle move to the forward (backward) without any operation , press the trim button backward
(forward) correspondingly , it can make the vehicle more stable.
3-4
8-9
5
6
7
10-11
14-15
12
13
Indicator
1) Indicating lamp intermittent flicker:said remote controller has not started, to the throttle stick
to push to the top end, and then drag the low-end before they can start remote controller.
2) Indicating lamp kept fast flash: said remote controller in on code state, with the receiver for code.
3) Indicator light: remote controller in flight control state.
When the fuselage is not smooth during flight, the aircraft can be placed on a horizontal position,
gyroscope correction.
Gyroscope
correction/Reset
7.Headless mode
adjust yaw trim,craft spins right or left
