![background image](http://html1.mh-extra.com/html/nutone/icudwh/icudwh_manual_1718926001.webp)
Page 1
MODELS ICUDWH • ICUNUW
BUILT-IN IRONING CENTER
READ AND SAVE THESE INSTRUCTIONS
INSTALLATION
1. Determine where to install. (Fig 1)
The NuTone Ironing Centers are designed to fit between standard 16” on-
center wall studs. A 46-1/4 ” x 14-1/4 ”x 4” deep opening is required. 24”
on-center studs will require framing to proper opening size.
When selecting the exact location for your cabinet, remember to leave room
for your door to open. The door can be mounted on either side of the cabinet.
It is recommended that you allow at least 55 inches wide and 44 inches
deep clearance around the ironing board. The ironing board will swivel to
either side so you will not need to be concerned about blocking a walkway.
However, if rotating the ironing board 90
0
in both directions, allow a total
width clearance of at least 68 inches.
CAUTION:
Make sure the location you choose is free of all electrical and
mechanical services. Also make sure that you have an electrical outlet nearby,
or have purchased the Deluxe Accessory (Model No. ICAK) for installation
into the Ironing Center cabinet.
2. Determine distance above floor. (Fig. 2)
The ironing center is designed to be easily installed between two 16”-on-
center wall studs. First determine the desired height of the ironing board
from the floor (Dimension a). Standard countertop height is 36”. Use the
chart below to find and mark the bottom of the wall opening (Dimension
b) - or - use the included template.
Desired Ironing Board Height
a
(Above Floor)
Height to Bottom of Opening
b
(Above Floor)
33 inches
22-3/4 inches
34 inches
23-3/4 inches
35 inches
24-3/4 inches
36 inches
25-3/4 inches
37 inches
26-3/4 inches
38 inches
27-3/4 inches
WARNING
1. Do not place EXCESSIVE WEIGHT (weight should not exceed 30
pounds) on the ironing board when opened as it is designed to accept
normal ironing use only.
2. Do not use ironing board surface as a shelf or as a child diaper-changing
surface.
3. To avoid getting pinched or otherwise injured, keep fingers/hands clear
of moving parts.
4. Allow iron to cool down before storing in the cabinet.
5. Empty water reservoir and turn off steam action prior to storing iron.
6. Unplug iron cord from outlet when storing, and use care to avoid pinch-
ing the electrical cord.
7. Keep ironing board stored and door closed when not in use.
8. Do not allow children to play with, on, or around the Ironing Center.
TOOLS NEEDED
• Tape measure
• Phillips screwdriver
• Drill with 3/32” dia. bit
• Stud finder
Fig. 1
To register this product,
visit: www.nutone.com
Wall
55"
Clearance
44"
Clearance
TOP VIEW
34"
Ironing
Board
Center Line
21"
Wall
Opening
b
46-1/4"
Floor
14-1/4"
16"
on-center
studs
a
Top of
ironing
board
Fig. 2
• Drywall saw or utility knife
• Level
• Pencil
Fig. 3
3. Cut the hole in the wall. (Fig. 2)
Locate the wall studs using a stud finder. Cut a 14-1/4”
x 46-1/4” opening in the wall between two studs using a
drywall saw or utility knife.
4. Close hinges. (Fig. 3)
Close the hinges so that they snap shut.