425-297-3162
Rev -
3” Rapid Z™-DRUM with Template Bearing
INSTRUCTIONS
Introduction
Thank you for purchasing the NSI Solutions 3” Rapid Z™-DRUM with Template Bearing. The
Rapid Z™-DRUM is a 3” vacuum brazed grinding drum designed to quickly grind and smooth stone and
quartz. These drums are designed to be used in sequence after the Rapid Z™-CUT. The coarse grit drum
will quickly clean up the rough surface left by the Rapid Z™-CUT. The fine grit drum will quickly smooth
the surface left by the coarse grit drum so it is ready to polish. Please read these instructions thoroughly
before using this tool. Keep these instructions in a place where operators can access it easily.
Use Proper Safety Gear
To prevent damage to eyes from flying debris, wear protective glasses or face shield. Be sure to wear
waterproof safety boots, appropriate hearing protection and dust protection as required.
Caution
Before each use, inspect the Rapid Z™-DRUM for damage. Never use a Rapid Z™-DRUM that has
damaged components.
Caution
The Rapid Z™-DRUM is designed for wet use only.
Caution
Maximum RPM 8500
Caution
Always be sure that the grinder is switched off and unplugged from power (either electric or air)
before installing/removing the Rapid Z™-DRUM or attempting to perform any inspection or
maintenance.
Tools Needed For Assembly/Disassembly
5/16” Allen (hex) wrench
Vise
Instructions
1.
The Rapid Z™-DRUM mounts to a male 5/8-11 thread (M14 thread on European version). Prior
to use, ensure it is mounted tightly.
2.
The Rapid Z™-DRUM is designed for wet use only. Use either center water feed or a sufficient
external water spray. Ensure enough water is used to avoid creating dust.
!
!
!
!
!
