Extra Wide Commode Range
General Safety Warning
Please ensure these instructions are fully read and
followed. Failure to do so may result in injury to
the user. Retain these instructions in a safe place
for future reference.
Intended Use
The Extra Wide Commode Range is primarily intended
to be used as a commode for toileting. It may also be
used as a seat support over a standard toilet (with
backrest and existing toilet seat removed) and, when
the seat cover is fitted, as a short duration bedroom
seat/chair or for occasional use in a shower. Side
transfers are possible with N10717 - removable arm
version. The seat height is adjustable on all variants.
Unpacking
Remove all parts from packaging, Check all parts are
present, refer to contents list below. Check for
damage. If you see, or suspect a fault, do not use the
product and contact your supplier.
Contents List
Item
Description
N10699 N10705 N10717
1
Commode Frame
1
1
1
2
Toilet Seat
1
1
1
3
PU Seat Cover
1
1
1
4
Potty
1
1
1
5
Potty Lid
1
1
1
6
Backrest
1
1
1
7
Leg
4
2
2
8
Leg/wheel Assy LH
-
1
1
9
Leg/wheel Assy RH
-
1
1
10
Removable Arm
(not shown )
-
-
2
11
Seat Fixing Screw
(not shown )
2
2
2
12
Seat Fixing Nut
(not shown )
2
2
2
13
Washer
(not shown)
2
2
2
14
E- Clip
4
4
8
N10699 Fixed Arms - 550mm wide
N10705 Fixed Arms - 660mm wide
N10717 Removable Arms - 660mm wide
User Instructions
Maximum
User Weight
Assembly Instructions
·
With the frame upturned, fit the legs, at the
required height, using the e-clips provided.
·
For N10699 fit all four legs. For N10705 &
N10717 fit the two legs without wheels to one
side of the commode frame; then fit the legs with
wheels to the other side of the frame with the
wheels in the orientation as shown in the picture
above. Turn the commode onto its legs and
check the legs are at the same height and the
frame does not rock.
·
To fit the toilet seat first unclip the plastic cover
on the seat hinges to reveal the fixing holes
·
Align the seat fixing holes with the holes in the
frame.
·
Place a washer on each fixing screw, and insert
them through the holes; secure from the other
side with the nuts provided. Note: the seat must
be secure, but do not over tighten the nuts.
·
Clip the plastic covers back to the hinge, to cover
the screws.
·
Fit the backrest in the desired position. Tip: the
backrest slides more easily into position if both
tubes are pushed into the frame at the same time
until the button clip engages to secure in place.
The backrest has three seat depth settings, to
move further inwards, depress the spring button
clips and push the backrest further into the frame.
·
Slide the potty into the commode, from the front,
using the rail wires on the underside of the frame
·
Place the potty lid on the potty if required
·
Fit the PU seat cover over the toilet seat.
N10717 only
·
Fit the removable arms, using the e-clips
provided, as shown in the picture above.
2
1
3
4
5
6
7
8
9
11
