1
Self Shaping
Lighted Whistler Pine Tree
151-0301-4
INSTRUCTION MANUAL
Thank you for purchasing this pre-lighted tree. This tree assembles in minutes and is decorated with CUL-listed
miniature light sets. A permanent contact shunt device is used in each bulb so when a bulb burns out the others
remain lighted. For your convenience, it is equipped with an on/off foot pedal switch for easy illumination.
This 7 1/2' tree is pre-strung with 1300 lights:
CARTON INCLUDES:
•
4 pre-lighted tree sections (A – Top Section, B – Upper Middle Section, C – Lower Middle Section, D –
Bottom Section)
•
1 sturdy metal tree stand
•
1 screw for tree stand
•
26 extra 2.5 V replacement bulbs
•
1 spare replacement fuse (5 A) for extension cord – note fuse is already in extension cord plug, slide
access panel to open (see
Fuse Replacement
below)
FOR INDOOR/SEASONAL USE ONLY
ASSEMBLY:
Note: Before you start to assemble your tree please choose a location near an electrical wall outlet. Place the tree
stand on a level surface.
Please remove protective covers from the base of the pole for each tree section before assembling.
1. Carefully insert the bottom section (C) of the tree into the stand. Make sure the pole is firmly inserted into
the stand and screw is tightly. Insert the lower middle section (C) of the tree into the bottom section (D),
insert the upper middle section (B) of the tree into the lower middle section (C), insert the top section (A)
into the upper middle section (B). (Figs. 1, 2, 3, 4)
2. Locate the light set plug from the top section (A) and plug it into the end connector of the upper middle
section (B). (Fig. 5)
3. Locate the light set plug from the upper middle section (B) and plug it into the outlet mounted in the lower
middle section (C). (Fig. 6)
IMPORTANT:
Do not remove the tape wrapped around the outlets of the extension cord mounted
in lower middle section (C). Any outlets you need to plug into are not wrapped in tape.
