TIMER OPERATION OF N4EU AND E4EU NOBO PANEL HEATERS
1
INITIAL OPERATION
1.1
The timer uses rechargeable batteries that need charging before the timer
functions can work. Before attempting any programming and before the heater
can be operated, plug it into a power point and turn it on using the O/I switch
on the side (I is on, O is Off). Allow around 5 minutes for the initial charge.
1.2
Use a pointed object, such as a pen or pencil, to clear the memory by pushing
the RST (RESET) button.
NOTE: The TIME button must be pressed and the OVERRIDE button switched
to the ON mode before the heater will operate. The flashing two dots in the
middle of the time display indicates clock is operating. The red light situated next
to the DAY button, when illuminated, indicates heater is operating.
2
TIME SETTING
Before attempting to program the timer, ensure that the correct time is set as
follows.
Please note that a 24hr timer is fitted to the heater. Thus 15:00 corresponds to
3:00 PM in the afternoon. Press and hold down the TIME button during the time
setting procedure.
2.1
DAY
Press and hold down the TIME button and press the DAY button simultaneously to
set the correct day. The day value increases by one by each push of the DAY
button.
2.2
HOUR (HR)
Press and hold down the TIME button and press the HR button simultaneously to
set the correct hour. The hour value increases by one by each push of the HR
button.
2.3
MINUTE (MIN)
Press and hold down the TIME button and press the MIN button simultaneously.
The minute value increases by one by each push of the MIN button.
Once the correct time settings are made, stop pressing the time button.
TIMERS
OPERATIONAL INSTRUCTIONS
