Congratulations on the purchase of your NiteSite product! Before you start to use the NiteSite system
please carefully read these instructions to enjoy optimum performance and a long service life.
There are three products in the RTEK spotting adaptor range for you to enjoy. The XE, XW and XV.
Please read the relevant information regarding your product purchase contained in this instruction
manual. NiteSite spotting adaptor product’s viewing ranges expressed are dependent on the spotting
scope and weather conditions.
Intended use
The NiteSite products are add on devices for use with an existing scope. They are also for
use in daylight. During darkness the NiteSite products will achieve a night vision identification
range of up to 500 metres depending on the model purchased, weather conditions and optic.
NiteSite Ltd does not bear responsibility for the use of this product in countries or territories where
the law prohibits its use. It is the sole responsibility of the operator to comply with the laws and
regulations of the country or territories where the NiteSite add on devices are used.
Your NiteSite product
Click on your model below to see the respective products kit contents
1
Operating instructions
Step 1
Place the Saddle bracket round the spotting scope, feed the velcro ribbon through the saddle
buckle and place the strap back on its self so that the saddle is firmly in place on top of the spotting
scope
Step 2
Slide the illuminator module into the “T” slot on the saddle bracket.
Step 3
Fit the spotting scope to the NiteSite aluminium bracket using the fixing screw provided. (spotting
scope bracket and fixing screws purchased separately)
Step 4
Push the flexible sleeve over the eye piece of the spotting scope. Push the camera in to the flexible
sleeve then fix the camera to the aluminium bracket. Make sure the camera and sleeve are fixed so
that the camera module is concentrically viewing down the spotting scope eye piece.
Step 5
Fit the battery pack in place (the XE model comes with a 6000 mAh battery in a pouch that
must be fitted to the spotting scope and not the flexible sleeve.)
Step 6
Connect the illuminator module to the camera module
Step 7
Connect the battery to the camera module and switch on the NiteSite system with the button on the
back of the camera module
