What’s In The Box
One (1) DCR
One (1) Edison Adaptor
WARNING:
•Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.
•To prevent early lamp failure, lamp should only be installed in operating environments
between -20°C and + 40°C (-4°F and 104°F)
•No user serviceable parts inside. To avoid electric shock do not disassemble product.
•This product is not intended for use in emergency light fixtures or exit signs.
ATTENTION:
Turn power off before inspection, installation, or removal.
Suitable for use in wet locations.
Use only on 120VAC, 60Hz circuits.
DCR56 Recessed LED Downlight
INSTALLATION INSTRUCTIONS
Model:
DCR56108120, DCR56112120
Tools Needed
The DCR Recessed LED Downlight is designed to fit into
a 5” or 6” housing with torsion spring receiving brackets.
For use in a 5” or 6” housing simply compress the torsion
spring arms inward until torsion springs line-up with
mounting brackets. No tools are necessary for installation.
Disconnect Edison base
from downlight and
screw into socket inside
recessed housing.
(GU24 base option available).
3
Carefully route wires into housing and push the
downlight upward, flush to ceiling surface.
6
4
Plug the downlight connector into the Edison
(or GU24) base connector.
Make sure all power is turned off before beginning installation
Squeeze torsion springs together and install into
torsion spring brackets inside recessed housing.
5
Carefully unpack the downlight from its packaging. Inspect product for defects due to shipping.
1
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393
www.nicorlighting.com November 9, 2017 9:13 AM
Installing the DCR
If using optional colored trim, align trim onto downlight and secure by bending over tabs.
2
5.00”
127 mm
5.71”
145 mm
Minimum Lamp
Compartment Dimensions
