Serial Label
X2-Cell Quick Start
For best results, setup your new system in the office/lab. Collect a few data
points and become familiar with the system prior to field deployment.
1
V2.WQDataLIVE.com/Getting-Started
2
Create a new account or sign into an existing account and enter the
Claim Code
found on the serial label to access the device’s data
3
Place the X2 in an area with
strong cellular coverage and
connect the antenna
4
Remove the center power
plug and required outer port
plugs (1 for each sensor to
connect)
5
Connect sensors to any outer
port (8 pin)
6
Connect power (5 to 24VDC)
to the center port (6 pin)
7
Wait up to 60 seconds for the blue cellular status LED to turn on
If the blue LED repeatedly blinks three
times, the cellular strength is
sufficient to connect the X2 with WQData LIVE
If the blue LED repeatedly blinks once, cell coverage is low. Move the
X2 to a location with better cell coverage and cycle power
8
Allow up to 5 minutes for sensor detection and data acquisition. The
detected X2 profile is sent to WQData LIVE along with new data
The blue LED will be on (solid) when setup is completed
9
Refresh the web browser and confirm that all connected sensors and
their parameters are displayed on WQData LIVE
