Should one of the eight 30-pin dock connectors inside the GripStand Station become damaged or non-functional,
discontinue using that charging slot until you have replaced the malfunctioning cable to avoid damaging an iPad!
The GripStand Station uses a custom shaped 30-Pin USB to Dock cable - replacement of the cable with any model
other than the approved Newer Technology 30-Pin USB to Dock cable will not work and will cause damage to the
GripStand Station.
The GripStand Station comes equipped with 72” USB to Dock cables from the factory and needs to be replaced with
the same. One extra replacement cable is included with the GripStand Station.
For extra replacement cables, please visit:
http://www.newertech.com/gripstandstation
GripStand
™
Station
Dock Cable Replacement
To remove a 30-pin dock cable, turn the GripStand Station so that you can see the rear and the dock cable channels.
Determine which cable you want to remove (in this scenario, the second cable from the bottom will be replaced).
Unscrew the four Phillips screws that secure the clear plastic cable cover (circled in red in step
➁
), and remove the
plastic cover.
Once the plastic cover is removed, locate the dock cable that you wish to remove. From the bottom of the
GripStand Station, lift up on the cable and remove it from the wire channel to release it.
➀
➁
➂
➃
