W410/BAT DISPLAY UNIT
MANUAL
Models: W410/BAT/D, W410XB/BAT/D
PREFACE
Thank you for purchasing the Navis anemometer. This manual provides information for the best performance and safe application of
the anemometer display unit. This manual does not cover the anemometer sensors for which the manuals will come separately.
Read this manual carefully before starting the installation. Keep this manual after installation for future reference.
INTRODUCTION
W410/BAT models are long-range receiver/display units which receive data from NAVIS wind sensors, display various wind data, and
use alarms for warnings about excess wind speed. Smartphone compatibility (W410XB/BAT model only) allows real-time wind data
monitoring on smartphones or tablets.
1. Display
2. Red and Yellow alarm lights
3. ON/OFF switch
4. Keys
5. Buzzer
6. SMA antenna connector
Figure 1. (W410/BAT display unit
– front panel)
The W410/BAT display is compatible with NAVIS sensors: WS 010-1 (wind speed sensor, standard range), WS 011-1 (wind speed
sensor, extended range), WSD 010-1 (wind speed/direction sensor, standard range), WSD 011-1 (wind speed/direction sensor, extended
range).
MOUNTING
Select the position where the signal reception is strong enough under all conditions. Use remote antenna if necessary.
Display unit can be mounted onto the ferrous surface with four mounting magnets (optional accessories) or with mounting screws (not
enclosed) to any flat surface.
Mounting the display unit with screws:
Unscrew all 4 plastic screws and remove the front panel. Note that the screws can be pulled out only at the correct angle. Place the
rear panel of the display unit to the final mounting position and mark the position for the bores. Remove the casing and drill holes for
the mounting screws. Place the rear panel of the display unit in position and tighten the mounting screws. Attach the front panel of the
display unit with 4 plastic screws.
ANTENNA CONNECTION
Connect the enclosed antenna to the SMA connector on the display unit only when the display unit is switched OFF.
OPERATION
Display unit is activated by a switch on the side of the housing.
If the display unit is delivered as a set, with the sensor included, the correct sensor address is already set.
Otherwise please set the correspondent sensor address first. Check the address settings procedure in the
chapter “SETTINGS”.
Turn the sensor ON by rotating the sensor cups (see sensor user manual).
Fresh wind data are received every two seconds. If data are not received for more than 30 seconds,
the “No data” notification appears
on the display.
