GS-65KT BLOWER INSTALLATION INSTRUCTIONS
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • 1(866)820-8686
• www.napoleonfireplaces.com
!
WARNING
ENSURE THE APPLIANCE IS COMPLETELY COOL BEFORE STARTING INSTALLATION.
TO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES AND CHILDREN.
DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY. KNOT BEFORE
THROWING AWAY.
W415-0506 / D / 07.11.17
Blower
(
see
location
and
clearances
in
instruction
manual
)
1. Cut and remove the tie securing the blower switch wires to the heat shield.
2. Connect the white wire coming from below the appliance to the terminal on the blower.
3. Connect the black blower wire to the black wire coming from below the appliance.
4. Insert the clips on the blower housing into the cutouts in the rear shield. Push down to lock the clips into position.
5. Secure the blower using the screw and lock washer supplied.
NOTE: Ensure that all the wires are contained neatly.
Switches
6. Open the switch housing by removing the top screw.
7. GDS20 (Fig. 1) & GDS25 (Fig. 3): Install the thermal disc bracket as shown, using 2 screws
(supplied). Connect the flagged leads to the terminals of the thermal disc.
GVFS20 (Fig. 2): Using the 2 screws supplied, fasten the thermal disc bracket to the extension
bracket already installed on the appliance.
8. Remove the knock out from the switch housing label. Install the variable speed switch
(rheostat) into the housing with the wires facing up. Secure the switch to the housing using a pal
nut and the knob (supplied).
9.Connect the male connector on the switch to the female connector coming from the appliance.
10. GDS20 & GVFS20 Only: Pilot Indicator Light: Install the batteries as shown. Replace the
batteries annually. NOTE: If replacing the pilot indicator light , ensure that the red wire lead
connects to the red lead of the thermopile and black to white.
11. Tuck all of the wires into the switch housing and close. Secure using the screw removed in
step 6.
This appliance comes equipped with a pilot indicator light
that blinks every few seconds when the pilot is on.
For more information see step 10.
2
3
4
4
5
1
7
7
8
9
GDS20 (Fig. 1)
THERMAL DISC
BRACKET
THERMAL DISC
EXTENSION BRACKET
INSTALLED ON UNIT
GVFS20 (Fig. 2)
4
5
8
2
3
1
9
7
7
4
GDS25 (Fig. 3)
