W415-2253 / 11.22.17
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • phone 866-820-8686 • w w w . n a p o l e o n h e a t i n g a n d c o o l i n g . c o m
KIT CONTAINS :
QTY DESCRIPTION
PART # KIT #
1
GRILL, ARCHITECTURAL FOR PSC
W305-0014 CAGMHA
1
GRILL, ARCHITECTURAL FOR PSS.PSE,PSH W305-0015 CAGMMA
8
SCREW, #8 X 1” HEX DRIVE TEKS SS
W570-0204
BOTH KITS
8
WASHER, 0.174ID X 0.375OD X 0.125” THK NYL 6/6 W735-0062
BOTH KITS
1
LEAFLET, ARCHITECTURAL GRILL INSTALL(CP) W415-2253
BOTH KITS
CONDO PACK ARCHITECTURAL LOUVERS (GRILLE)
Ensure all parts are in the kit before
proceeding.
Do not proceed if parts
are missing.
PROCEDURE
(
Please read entire instructions first.)
8x
8x
IMPORTANT
!
!
TESTING HAS SHOWN THAT THE INSTALLATION OF
ARCHITECTURAL GRILLE AFFECTS THE NORMAL
OPERATION OF THE CONDO PACK UNIT UNDER
CERTAIN OPERATING CONDITIONS.
THE FACTORY INSTALLED
UPPER STAMPED GRILLE
MUST BE REMOVED
FROM THE CONDO PACK
CABINET, PRIOR TO UNIT INSTALLATION INTO A WALL
SLEEVE. NO UNAPPROVED ARCHITECTURAL
GRILLE IS ALLOWED. UNAPPROVED
ARCHITECTURAL GRILLE AND IMPROPER
INSTALLATION WILL LEAD TO DETERIORATION
OF THE PERFORMANCE AND PREMATURE FAILURE
DUE TO ADDED RESTRICTION TO AIR FLOW.
IMPORTANT
!
!
THE GRILLE MUST BE SEALED ON ALL FOUR SIDES.
IN ORDER TO PREVENT WATER RUNOFF DIRECTLY
ONTO THE FINISH WALL, IT IS RECOMMENDED TO
INSTALL FIELD-SUPPLIED FLASHING UNDERNEATH
THE BOTTOM OF THE LOUVER.
Align the grille with the TOP wall sleeve panel
TOP wall sleeve panel
Architectural Grille
3
ARCHITECTURAL GRILLE IS DESIGNED TO BE INSTALLED
ONTO A WALL SLEEVE PRIOR TO CONDO PACK
INSTALLATION. IT IS RECOMMENDED THAT THIS STEP IS
PERFORMED AFTER CONSTRUCTION PHASE
HAS BEEN COMPLETED.
STEP 2.
Use factory provided (8)
self-drilling screws and
(8) washers to fasten the grille onto wall sleeve .
Use only factory provided
plastic washer with screws. If not used, the screws will
damage the cabinet and obstruct the removal of the
cabinet at the end of life cycle.
STEP1.
Align the architectural grille with the top wall sleeve panel.
1
2
STEP 3.
Insure wall sleeve is sealed properly according to wall sleeve
installation procedure. Caulk all seams between the grille and
the FINISHED exterior walls. Seal the spaces using non-
hardening caulking compound. All seals must be weather
tight to prevent entrance of moisture and water into the
building. Care must be taken not to plug the drain openings.
DRAIN OPENINGS
DO NOT PLUG THE DRAIN OPENINGS
8
1
2
3
4
WASHER,
0.174ID x 0.375OD x
0.125" THK NYL 6/6
#8 x 1" HEX DRIVE TEKS SS
ARCHITECTURAL GRILLE
5
6
7
(CAGMHA - for PSC CONDO PACK)
(CAGMMA - for PSS, PSE and PSH)
INSTALLATION INSTRUCTIONS
