MOTIVE-RC
MOTIVE-RC
2.4GHz R8SB
D8_Mode Compatible Telemetry Receiver
INSTRUCTION MANUAL
Thank you for purchase of the R8SB receiver.
This manual contains the complete direction on how to use this receiver, we encourage you to review the entire
manual before using these products.
R8SB receiver is designed for iRange X, Jumper, and FrSky Radio D8 Model system, please check the compatibility
before use!
Main Features
1. 1.2km far reaching range.
2. Satisfy with various model type with Physical channel PWM outputs, PPM, SBUS and RSSI outputs(For FC).
3. RSSI Output analog 0~3.3V.
4. Two analog telemetry ports (A1&A2) , A1 for internal receiver battery voltage sensor, A2 for external battery
voltage sensor(0~30V,1~6S).
5. One digital data-stream port (Rx,Tx).
Layout and LED definition
*set different signal output by bind in different mode.
Specifications
Size: 35 x 21 x 12 mm (L x W x H)
Weight: 6.8g
Number of Channels: Up to 9CH from SBUS(CH1~8 for PWM, CH9 RSSI for FC)
Input Voltage Range: 3.5V - 13.0V (5V Normal Operating Range)
Range: above 1.2KM
Compatibility: iRange X , Jumper Transmitters, FrSky DJT/DFT/DHT, D8_Mode on all FrSky transmitters
Antenna installation:
R8SB receiver is made for high directivity consisting of two antenna, in order to maximize signal reception and
promote safe modelling has adopted a diversity antenna system. This allow the receiver to obtain RF signal on both
antennas and fly problem-free.
Be sure that the two antennas are placed at 90 degree to each other, and keep away from conductive materials to
avoid short circuit.
Linking to Transmitter
Step 1:
Set R8SB receiver in Binding mode FIRST
and Select operate mode you want (Please reference below sheet ):
Connect battery to R8SB receiver while holing the F/S button on the receiver enter binding mode.
Mode select:
1. Set receiver in binding mode;
2. Each press of the F/S button advances the receiver to the next Mode, when you reach the mode that you wish to
operate in, short press the button.
3.Once locked into the correct mode the LED will flashing in corresponding times constantly.
R8SB RECEIVER CHANNEL MODE SHEET
* Only PPM/SBUS Capable devices may be connect to the PPM/SBUS port. Analog servo or gyros should not be connect on
PPM/SBUS port.
RED LED
GREEN LED
INDICATING
ON
FLASHING
LINKING
OFF
ON
NORMAL
FLASHING
OFF
NO SIGNAL
FLASHING
FLASHING
FAILSAFE
Receiver
output
Connector
Channels
Mode 1
CH 1~8
Normal Mode (20mS)
Mode 2
CH 1~8
High Speed Mode (3mS)
Mode 3
CH1~7 +
CH8 PPM
Mode 4
CH1~7 + CH8
SBUS/RSSI
1
1
1
1
1
2
2
2
2
2
3
3
3
3
3
4
4
4
4
4
5
5
5
5
5
6
6
6
6
6
7
7
7
7
7
8
8
8
PPM
8Channels of Outp
ut w/ 9th Channel
Dedicated to RSSI
Red LED
Blink
1 time
2 times
3 times
4 times
