See www.routerboard.com for more information. Contact [email protected] for support questions.
21-Aug-13
RouterBOARD 912G-‐5HPnD
Quick Setup Guide and Warranty Information
RB912G is a dual chain 5GHz 802.11n wireless device with a Gigabit
Ethernet port. Two models are available with 5GHz wireless:
RB912UAG-‐
5HPnD
(miniPCIe, SIM slot for 3G, USB 2.0 port, 64MB RAM), and
RB911G-‐5HPnD
(32MB RAM, no SIM, no USB, no MiniPCIe).
First use
•
Connect antenna cables to the built in Wi-‐Fi connectors
•
Device accepts 8-‐30V with a passive PoE powered Ethernet ca-‐
ble or with a power connector to the Power Jack
Powering
The board accepts power with the following modes:
•
With PoE to Ether1 port. It accepts 8-‐30V DC input (at the
board; higher voltage needed to compensate for power loss on
long cables; at least 18V suggested) from non-‐standard (pas-‐
sive) Power over Ethernet injectors (no power over data lines). The board
does not
work with IEEE802.3af compliant
48V power injectors.
•
Direct input to the power jack 8-‐30V
Booting process
RouterOS is the operating system of all RouterBOARD routers. Please see detailed configuration guide here:
http://wiki.mikrotik.com/wiki/Category:Manual#list
This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the Ethernet cable, using
the MikroTik Winbox utility. Winbox should be used to connect to the default IP address of
192.168.88.1
with the username
admin
and
no password
.
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the de-‐
vice when starting it until the LED light turns off, and Groove will start to look for Netinstall servers.
In case IP connection is not available, Winbox can also be used to connect to the MAC address of the device. More infor-‐
mation here:
http://wiki.mikrotik.com/wiki/First_time_startup
Extension Slots and Ports
•
One Gigabit Ethernet port (With Auto MDI/X so you can use either straight or cross-‐over cables for connecting to
other network devices). The Ethernet port accepts 8-‐30V DC powering from a passive PoE injector.
•
Built-‐in 802.a/n WiFi card (AR9342) with two MMCX connectors
•
Only RB912UAG-‐5HPnD
: miniPCI-‐e slot for either a 802.11 Wireless card, or a 3G modem (when a 3G modem is
used in miniPCIe slot, USB port will become inactive. In RouterOS you can select which of the 3G modems you want
to use, USB or miniPCIe). SIM slot is available for miniPCIe 3G cards.
•
Only RB912UAG-‐5HPnD
: USB 2.0 port
