See www.routerboard.com for more information. Contact [email protected] for support questions.
23-May-2012
RouterBOARD 2011U series
Quick Setup Guide and Warranty Information
The RB2011 is a small form factor ethernet router with 5 Gigabit Ethernet ports and 5 Fast Ethernet ports. The RB2011U
series includes two models
RB2011US-‐IN
(USB, SFP, indoor case) and
RB2011US-‐2HnD-‐IN
(also includes wireless functionality
and indoor antennas).
First use
The device comes preinstalled with RouterOS and is ready to use. RB2011 is compatible with RouterOS v5.9 and newer, if
your device comes preinstalled with an earlier version, please upgrade before using it.
The Ethernet ports 2-‐10 have a default IP address for connecting:
192.168.88.1
username is
admin
and there is
no password.
Please connect with your web browser to this IP address and choose Webfig to configure it.
Ether1
is configured as a DHCP
client, for connecting to your ISP.
See this page for connection and configuration guides:
http://wiki.mikrotik.com/wiki/Category:Manual
Powering
The device accepts powering from either the power jack, or from the LAN1 Ethernet port:
•
Direct-‐input power jack (5.5mm outside and 2mm inside diameter, female, pin positive plug) accepts
8-‐30V DC (overvoltage protection starts at 30V).
•
Eth1 port accepts 8-‐30V DC input (at the board; higher voltage needed to compensate for power loss on long cables)
from non-‐standard (passive) Power over Ethernet injectors. The board
does not
work with IEEE802.3af compliant
48V power injectors
•
The IN and RM models include a 110/220V PSU which is already plugged into the power jack inside the case
Extension Slots and Ports
•
Five 10/100/1000 (Gigabit) Ethernet ports (Auto MDI/X)
•
Five 10/100 (Fast) Ethernet ports (Auto MDI/X)
•
One 8-‐30V DC power jack
•
SFP port for SFP module (module not included)
•
(on RB2011US-‐2HnD-‐IN) built in 2GHz wireless device with external antennas, 802.11 b/g/n modes supported.
