1.
2.
nRAY series
Wireless Wire nRAY (nRAYG-60adpair)
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
All installation methods for mounting an access point on any wall surface is subject to the acceptance of local jurisdiction.
The Installation of the equipment must comply with local and national electrical codes.
This product is intended to be mounted outdoors on a pole but can also be installed indoors. Please read the mounting instructions carefully before
beginning installation. Failure to use the correct hardware and configuration or to follow the correct procedures could result in a hazardous situation to
people and damage to the system.
Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your
own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling
requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.
This is a class A device. In a domestic environment, this product might cause radio interference in which case the user might be required to take adequate
measures.
Quickstart
Please follow these quick steps to set up your device:
Unscrew the cover to reach the Ethernet port;
Guide Ethernet cable through the opening;
Plug into the Ethernet port and screw clockwise tightly, to ensure water protection;
Connect the PoE injector into the computer;
Connect the power adapter to the PoE injector;
Download WinBox configuration tool
, or use Web browser;
Default IP: 192.168.88.2 and 192.168.88.3, user name:
and please find the password on the sticker;
admin,
By default devices are configured as W60G Bridge;
Once connected, configure the device, so it has an active Internet connection
, or proceed to the next step to upgrade
software manually;
Upgrade the RouterOS software to the latest version
;
Connect again and choose your Region, this can be done in the Wireless menu W60G tab;
Double click on the W60G interface, go to the Wireless tab and choose your Region;
Powering
The device accepts power 802.3af/at PoE in 12 – 57 V DC .
The power consumption under maximum load can reach 6 W.
Connecting to a PoE Adapter:
Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.
