4
. CONNECTIONS
The following diagram shows the connections on the
underside of the subwoofer.
Digital Channel
Selector
Power Inlet
2
1+2
1
Input
Output
SpeakerLink
Channel
selector switch
SpeakerLink
output
Power Fuse
Use this connection
To connect to this
SpeakerLink input
The SpeakerLink output of a
Meridian Surround Controller,
Digital Pre-Amp, Digital Theatre
Controller, or the SpeakerLink
output of another DSP loudspeaker.
SpeakerLink output
The SpeakerLink input of another
DSP loudspeaker in the same
daisy-chain as the DSW.2, or the
SpeakerLink input of another
DSW.2.
5
. POWEr uP ThE DSW.2
Power Inlet
Power up the DSW.2 with the
supplied power cable.
This guide explains how to install the DSW.2 subwoofer. For
further information please visit:
meridian-audio.com/DSW2
1
. uNPACkINg
The DSW.2 weighs 22kg (48.4 lbs), so appropriate manual-
handling precautions should be taken when removing the
product from its carton.
Take care not to damage the outer finish of the DSW.2 while
handling the product.
The DSW.2 is supplied with the following accessories:
Power cord.
Three rubber foot inserts.
If any of these items is missing, please contact your dealer.
NOTE: You should retain the packaging in case you need to
transport the unit.
2
. FIT ThE ruBBEr INSErTS
As supplied, the feet of the DSW.2
are suitable for soft carpeted
surfaces. To use the DSW.2 on a hard
surface, insert one of the supplied
self-adhesive rubber inserts into the
recess on each foot.
3
. CONFIgurATION
The DSW.2 can be used in a variety of roles in a Meridian
system. This flexibility makes it necessary to configure one or
more of the Meridian products within the system in order for
the DSW.2 to perform as intended.
For further details of the configuration required see the
support pages for the DSW.2 and the other products in the
system on the Meridian website.
•
•
6
. ChANNEL SELECTOr SWITCh
If the DSW.2 is installed in a two-channel system:
Set the channel selector switch as follows:
1
left channel
2
right channel
1+2
a balanced mix of left and right channels
If the DSW.2 is used to play the dedicated Mono or LFE
subwoofer channel from a Meridian Surround Controller:
Set the switch to 2.
If the DSW.2 is used to extend the bass of a single
loudspeaker or a pair of loudspeakers in a surround system:
Set the switch as follows:
1
to extend a left-sided channel or the centre-channel
2
to extend a right-sided channel
1+2
to extend a left and right pair of channels
If the DSW.2 is used with the Meridian 271 Digital Theatre
Controller
refer to the documentation on the 271 support page on the
Meridian website.
7
. FurThEr INFOrMATION
To access the DSW.2 user guide,
datasheet, FAQs, and for further
product support, please visit:
meridian-audio.com/support/DSW2
Or, scan the Qr code here.
input
