installation
&
care
instructions
REVISION: 04/2018 | page 1 of 4
GENERAL ADVICE
Please follow these instructions carefully to ensure
trouble free operation.
• Inspect the product for damage carefully before installation.
No claims for damage can be accepted after installation.
• Ensure all pipework is flushed free of debris before installation.
• Installation must be in accordance with local authority regulations.
• We recommend a service valve is fitted to the hot & cold supplies.
• Ensure supply pipes are properly sized to avoid problems with
flow rate, pressure loss or water hammer.
• We recommend the installation is protected with water filters,
water-hammer arrestors and water pressure reducers as required.
• Do not install where there is the possibility of the water
supplies freezing.
• Recommended minimum water pressure 1.5 Bar (22.5psi).
Maximum water pressure 5 Bar (75psi).
• Maximum recommended water temperature 55ºC (131ºF).
• Leave this Manual with the operator after installation.
Thank you for purchasing your AquaJet product.
INSTALLATION &
CARE INSTRUCTIONS
AJPR50-2
- PRE-RINSE PRODUCT
