Installation Instructions
Hustler Collinear Two Meter Fixed Station Antenna
Master Gainer™ Model G6-144B
Warning
INSTALLATION OF THIS PRODUCT NEAR POWER LINES IS DANGEROUS.
FOR YOUR SAFETY, FOLLOW THE INSTALLATION DIRECTIONS.
GENERAL DESCRIPTION
FCC accepted for Repeater application at 6db gain based on EIA Standard RS-329: gain compared to
1/2 wave dipole.
ASSEMBLY INSTRUCTIONS
1.
Check package contents against illustration to insure all items are included.
Note: One corner of the flange which the radials are mounted on has a metal strip installed
over the screw hole.
2.
Refer to Figure 1 and install the four radials. This is most easily accomplished by inserting
the four #5180-3 screws two or three turns into the #5328 cast aluminum base. Note the
clockwise direction and install all radials before tightening the four screws. Hold the base
assembly in a vertical position while installing radials. Install red tips on ends of radials.
3.
Attach the phasing coil and upper radiator to the lower radiator and base assembly. Tighten
the assemblies securely.
4.
Mount the antenna on a 1” to 1 3/4” diameter mast with the “U” bolts supplied.
TUNING INSTRUCTIONS
After the assembly is complete, install a dependable watt meter at or near the feed point of the antenna.
The G6-144B utilizes a 5/8 wave lower and a 5/8 wave upper collinear radiator which has been spaced for
optimum low angle radiation.
Apply power to the antenna or near the center of the frequency range to be used. Reference: See last paragraph.
Loosen the clamp of the bottom radiator only and adjust the length until the lowest reflected power or SWR is
obtained. Secure this clamp. If it is desired to further minimize the reflected reading, loosen the clamp of the top
radiator and adjust this length until the lowest possible reading is obtained. Adjustment increments should be in
steps of no more than 1/2 inch.
Secure all hardware and clamps
Before final installation, if desired, coat the entire antenna with the exclusion of the rf connector with a good grade
acrylic lacquer such as “Krylon”.
The total useable bandwidth is more than 2MHz under 1.5:1 without degradation of gain which makes the antenna
idea for duplex operation.
When using some other frequency in that range, add or subtract 1/4” from each “X”, “Y” dimension for each .5
MHz. Lower or higher change in frequency, respectively.
Newtronics Limited Warranty
Newtronics Antenna Corp. warrants its products to be free of defects in material and workmanship and extends this warranty under intended
use and normal service conditions to the original owner for a period of one year from the date of purchase.
This warranty does not apply to any product that has been repaired or altered in any manner and is void for any damage due to accident,
neglect, unreasonable use, improper installation or any other cause not arising out of defects in material or workmanship. The obligations of
Newtronics Antenna Corp. are limited to repairing or replacing, at its option any product or part that is returned to the factory, all transportation
charges prepaid, accompanied by proof of purchase and which examination reveals to have been defective within the warranty period stated
above.
Newtronics Antenna Corp. does not assume, nor is any person authorized to assume for it, any obligation other than that herein stated.
Any implied warranties, including by not limited to fitness for a particular purpose, are limited in duration for the above one year period.
Newtronics Antenna Corp. shall not be liable under this warranty or any implied warranty, for loss of use of the product or for other
consequential loss of damage incurred by the purchaser.
Some states do not allow the exclusion of limitations of implied warranties of consequential damages and so the above exclusions of limitations
may not apply in those states. This warranty gives you special legal rights and you may have other rights that vary from state to state.
G6-144B
Kit #6079
This PDF courtesy of
