Installation Instructions
1 | P a g e
v 1 . 1 ( 1 2 / 2 0 1 8 )
TORANT LED FLOOD LIGHT
SKU# 231078, 231079
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality MFL product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.
Warranty
•
This luminaire is covered by a 3 year warranty. The warranty is from date of purchase, not the date of installation.
•
If the luminaire is not assembled and installed by a licensed electrician the warranty will be void.
•
Please retain proof of purchase and evidence of assembly and installation by a licensed electrician.
•
Warranty will be void if there is any damage due to improper usage or modification to the luminaire.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
•
The use of non-tested dimmers may damage your LED luminaire and will void your warranty.
Installation Requirements
•
This luminaire must be assembled and installed by a licensed electrician.
•
All wiring and installation of the luminaire must adhere to latest local and national wiring rules.
eg. AS/NZS 3000 Electrical installations.
•
This luminaire is a Class I product and must be earthed.
•
Select a suitable location for installation:
- This fitting is protected against water penetration to IP65 standards, which is against low pressure jets of water
from all practicable direction. This must be maintained during installation.
- It is suitable for indoor or outdoor use.
- The mounting point must support 2 times the weight of the fitting.
•
This luminaire is dimmable and has been tested at the date of publication with the dimmers listed in the specification
section. The use of a LED dimmer such as the Lucci LEDlux SKU# 290998 dimmer is highly recommended.
•
NOTE: For the best dimming range, use with the Lucci LEDlux SKU# 290998 dimmer and adjust the variable
resistor at minimum and maximum dimming positions on the dimmer during the installation.
•
NOTE: Dimming may cause buzzing sounds or a slight flicker. There may be slight delays with the LED light start up
or slight uneven light performance when more than one LED luminaire is linked together, switched ON or dimmed.
This is not a product fault and as such is not covered under warranty.
•
NOTE: Some dimmers have a minimum load of 20W. Ensure the dimmer position is on the maximum setting before
turning on the LED light and adjust the dimmer down to your desired light level.
•
NOTE: Testing cannot account for installation variables such as variation in mains supply voltage, cable
capacitance, electrical noise, transients, surges and ripple control signals (commonly found in NSW & QLD).
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.
