SK110 Issue 8 © 2017
Page 1 of 4
INSTRUCTION MANUAL
Introduction
SINGLE PEDESTAL
METAL HOSE REEL
Important Information
PLEASE READ THIS SAFETY INFORMATION
CAREFULLY BEFORE USE.
Read and retain this instruction manual to assist you in the
operation and maintenance of this product.
‘Cautions’ are listed throughout this manual to advise of
actions that may cause damage to your equipment.
Installation Procedure
CAUTION
Make sure the line pressure does not exceed the rated
operating pressure of your model hose reel, refer
specifications.
CAUTION
Exposure of the skin directly to pressurized air or fluid
could result in severe bodily injury.
CAUTION
Before carrying out any maintenance turn off and
disconnect the supply line to the reel and carefully
release the hose line pressure.
5) Using the four holes in the base, mount the reel in the
desired location. Be sure to use the appropriate hardware
and tighten securely.
6) Apply Teflon tape or pipe sealant to supply line threads,
attach to reel and tighten. The other end of the oncoming
line can now be connected to the desired supply source.
Tighten stopper bolts, and unlatch the reel.
7) Apply Teflon tape or pipe sealant to the outlet fitting on
the hose, then attach the desired tool or nozzle. Check
connections for leakage, also check hose reel for correct
operation. (See Operation section)
Thank you for purchasing a Heavy Duty Metal Hose Reel.
The range of single pedestal reels have been designed
using the highest quality, heavy gauge materials and are
fitted with purpose specific hose and swivels. Models
available are for Air/Water, Oil and Grease
1) For overhead ceiling mounting: Install reel at least 3m
(10 feet) above the floor.
2) You will need to purchase the appropriate hardware for
mounting your new reel.
3) The reel base has four 1/2” (12.7mm) drilled holes for
mounting on a suitable flat surface.
4) The reel is supplied with a hose guide roller bracket.
The roller bracket position may be changed depending on
the reel mounting position. Figure 2 shows “ Typical
mounting positions”. If the bracket position needs to be
changed, do the following:
A) Pull out some hose and let reel latch.
B) Remove the 4 bolts that attach the guide roller bracket
to the support post.
C) Rotate guide roller bracket to correct position, then
replace all bolts and tighten.
Includes m odels
MAS1020-01
MAS1220-01
MOS1220-01
MGS0615-01
