DETAIL A
Procedure sheet.
IN
Creation Date :25/09/2014
Sheet No.
of
1
Procedure for installing and removing MACPanel DAK.
* Failure to follow these procedures will result in damage to either the DAK screws
or Receiver frame and add stresses to the DAK / PXI Card assembly *
Installation.
1) Slide the pre-assembled DAK / PXI card assembly into the assigned card slot.
Push in until the DAK screws touch the receiver top and bottom rails.
2) Using a 4.5mm flat bladed screwdriver, screw in the BOTTOM DAK screw first (Detail A)
This will engage the PXI card into the chassis backplane.
Once the bottom screw is properley seated, only then should the TOP screw be secured.
BOTTOM
screw
MUST
be secured
FIRST
.
Your DAK / PXI card assembly is now correctly installed in the
SCOUT receiver and PXI Chassis.
2
91300
PXI Chassis
SCOUT Receiver
Top Rail
Bottom Rail
DAK / PXI Card.
Bottom Screw MUST
be Tightened FIRST
Top Screw MUST
be Tightened LAST
