Lutron Electronics Sunnata HRST-PRO-N, Manual

Page: 1 / 15

Sunnata Dimmer MyLevel Personalization
Application Note #734
Revision F
November 2021
1 Customer Assistance — 1.844.LUTRON1
®
Default Settings
Feature Default
High-end trim Highest level of trim range
Low-end trim Middle level of trim range
Light level indicator / Locator light ON /ON
Light bar brightness Medium brightness
Preset light level Tapping the ON button always sets the lights to full (locked preset at high-end)
Glossary: . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
High-End Trim: Adjust the maximum light level of the load . . . 3
Low-End Trim: Adjust the minimum light level of the load . . . 4
Phase Select Mode (PRO-N only): Select to operate in
forward- or reverse-phase dimming . . . . . . . . . . . . . . 5
Preset Light Level: Change the behavior of the device
when the ON button is pressed from the OFF state to ON . . . 7
Light Bar Brightness: Select between high, medium,
and low brightness of the control’s light bar . . . . . . . . . . 10
Light Level Indicator / Locator Light: Select between ON and
OFF for the light bar when not interacting with the control . . 12
Restore Factory Default Settings:
Return the control to its original settings . . . . . . . . . . . 14
System Features:
. . . . . . . . . . . . . . . . . . . . . . 14
Dimmer
FA
SS
•
FA
S
S
•
FAS
S•
FA
SS
•
FA
S
S
•
FAS
S •
On
Off
(Front Accesible Service Switch)
FASS
Adjust:
(Light Bar)
• Touch light bar to set
lamps to desired level .
• Slide to adjust light
level .
LED 9
LED 8
LED 7
LED 6
LED 5
LED 4
LED 3
LED 2
LED 1
en español / en français
Overview
MyLevel personalization gives you the ability to customize your Sunnata touch dimmer . From the main dimmer, you can
adjust the brightness of the light bar as well as set a favorite level using the Feature menu . Before adjusting these features,
it is important to have a good understanding of the advanced features . MyLevel personalization cannot be entered from a
companion dimmer . Companion dimmers will match the settings of the main dimmer .
Identify your main dimmer:
Pull the FASS (Front Accessible Service Switch) out and push it back in . If the light bar blinks, this is your main dimmer .
If not, go to your next location in your installation and repeat until you locate your main dimmer .
Easily adjust your dimmer in 5 steps:
1.
Enter Feature menu
2.
Select the feature you want to change
3.
Change the feature
4.
Save the setting
5.
Exit
For instructional videos on how to adjust features, visit www .lutron .com/sunnatasupport
Sunnata Models
ST-PRO-N Sunnata PRO Dimmer STCL-153P Sunnata LED+ Dimmer
RRST-PRO-N Sunnata RF Dimmer STCL-153M Sunnata LED+ Dimmer
HRST-PRO-N Sunnata RF Dimmer