IMPORTANT INSTRUCTIONS
C1317US - 2006_07_REV001
For Installation LS482
MODELS
LS482
Mains Voltage depicted 12V version available
Check fixture for wattage.
A.C.N. 010 572 773
Relamping
4
1
2
3
Note: To achieve IP66 rating, use round cable (size 5-10mm) to suit entry gland supplied with fixture.
US Head Office
Telephone
Fax
1300 Industrial Rd., Unit #19
San Carlos, CA 94070
USA
1-(650)-595-LUMA(5862)
1-(650)-595-5820
Free Call
www.lumascape.com
(US & Canada)
1-866-695-LUMA(5862)
LUMASCAPE USA INC.
INC.
Mounting fasteners
not supplied by
Lumascape
Surface Mount Plate
300mm
(1
1.8in)
Direct Burial Post
Mounting fasteners
not supplied by
Lumascape
Discreet Mount
Outside Diameter
Ø150mm
Remove lid from fixture
and pull out gear tray.
Pull cable through gland
and tighten.
Connect leads to
terminal block.
Slide gear tray back into
mounting pole.
Wire up fixture
Check wattage and
insert lamp into fixture.
Test to ensure lamp and
fixture is operational.
Insert lamp into fixture
Put lid on fixture
and seal by
tightening all
three screws
around the base.
Fit cover & seal
1
2
Open fixture as shown in
.
Remove old lamp from fixture as shown below.
step 2
3
4
Insert lamp into fixture as shown in
.
Seal fixture as shown in
.
step 4
step 5
PCD Ø120mm
Hole Size Ø11mm
Warning
Rubber seal protects gear tray from moisture.
Do not use force. Make sure seal fits tightly against pole.
